Hubs

Dodgy Dave · Post by **Dodgy Dave** » Fri Apr 08, 2005 2:22 pm

how do you remove the hubs from the corsa

BAD ASS CORSA · Post by **BAD ASS CORSA** » Sat Apr 09, 2005 8:40 am

very roughly, remove wheel, undo hub nut (24mm) and pull like a c**t being care full not to drop bearings on the floor.

Poundie · Post by **Poundie** » Sat Apr 09, 2005 9:54 am

Yup!.

Dodgy Dave · Post by **Dodgy Dave** » Sat Apr 09, 2005 10:04 am

so thats all it is then to get the hubs off, can i also bash it out if im carefull

BAD ASS CORSA · Post by **BAD ASS CORSA** » Mon Apr 11, 2005 11:25 am

As poundie said, \"yup\". Just be care full not to drop the bearings.

Dodgy Dave · Post by **Dodgy Dave** » Mon Apr 11, 2005 9:38 pm

cheers folks, i will do that

Dodgy Dave · Post by **Dodgy Dave** » Fri Apr 15, 2005 3:42 pm

i still cant get them off

BAD ASS CORSA · Post by **BAD ASS CORSA** » Fri Apr 15, 2005 8:06 pm

Have you tried a little persusion? Lever bar or somethin like that.

Dodgy Dave · Post by **Dodgy Dave** » Sat Apr 16, 2005 1:29 pm

yea i have, and i have tryed a hammer but they still wont budge

Dodgy Dave · Post by **Dodgy Dave** » Sun Apr 17, 2005 3:42 pm

mikeycorsa241 · Post by **mikeycorsa241** » Mon Jun 13, 2005 9:30 pm

get to block ofmetal put them behind the hub between hub and the nuckle then put two wheel bolts in thehole that the blocks are behind and wind the nuts in and it will pop the hub off

j1400 · Post by **j1400** » Mon Jun 13, 2005 10:11 pm

If you mean rears,

first make sure the nad break of off, then get a coupel of spanners, 13 and 15 are my fav\'s and then screw them on to the drum on opposing sides and then wiggle them to pull the drum off.
also when you wiggle it normally shoots the front roller bearing out for you, and put it on a bit of kitchen roll.

Dodgy Dave · Post by **Dodgy Dave** » Tue Jun 14, 2005 2:53 pm

cheers for the info guys but the hubs got done about a month ago