Kirb bump :(

Help and advice section for technical questions on your Corsa.
Please check that your query hasn't already been answered in FAQ and Technical Info section.

Moderator: Octane2097

Post Reply
User avatar
Robbo173
CB-Uk User
Posts: 220
Joined: Wed Nov 17, 2010 3:53 pm
Location: Wirral

Kirb bump :(

Post by Robbo173 »

I was in a car park, messing around lol when i bumped the O/S rear wheel on a 2 ish inch kirb, i was only going slow but would this be enought to cause any damage to the back axel? :/
User avatar
PRICER
CB-Uk User
Posts: 3510
Joined: Sun May 10, 2009 9:21 pm
Location: ludlow shropshire

Re: Kirb bump :(

Post by PRICER »

no doubt it, why has it started making any weird noises? what you could do is just check the wheel bearing but cant wee what damage it'd do tho, more than likely damage your wheel more than the axle if anything at all.
TURBO LAG IS JUST FOREPLAY ;)

2.0 16v GSI SPORT TWIN WEBER 45'S AND KENT CAMS :]
User avatar
Robbo173
CB-Uk User
Posts: 220
Joined: Wed Nov 17, 2010 3:53 pm
Location: Wirral

Re: Kirb bump :(

Post by Robbo173 »

Not making any weird noises just getting a bit worried if it may suddenly fail whilst im driving :/
User avatar
PRICER
CB-Uk User
Posts: 3510
Joined: Sun May 10, 2009 9:21 pm
Location: ludlow shropshire

Re: Kirb bump :(

Post by PRICER »

just check the wheel bearing, and your wheel make sure its still round, but with a wheel bearing minus the drum contact noise with the pads it should sound smooth, you can tell if ones gone anyway because the wheel will, well.. move side to side.
TURBO LAG IS JUST FOREPLAY ;)

2.0 16v GSI SPORT TWIN WEBER 45'S AND KENT CAMS :]
Squisheh
CB-Uk Newbie
Posts: 36
Joined: Tue Nov 16, 2010 6:21 pm

Re: Kirb bump :(

Post by Squisheh »

jack the wheel up so its off the ground, spin it round with your hands and listen for any unusual noises, then grab left and ride side try and turn the wheel slightly, see if there is any give in it, with it being the rear wheel there shouldn't be any i don't think, so if there is its probably the wheel bearing, i need to change rear wheel bearings on mine and thats how the garage found out by doing them checks :)
Post Reply