CORSA 1.0 12v OIL PREESURE LIGHT AND EML
Moderator: Octane2097
-
- CB-Uk User
- Posts: 111
- Joined: Sat Nov 20, 2010 4:00 pm
CORSA 1.0 12v OIL PREESURE LIGHT AND EML
I've had nothing but problems with my girlfreinds car recently - 1999 1.0 12v
The most recent problem however is when the engines been running for bout an hour everytime the engine idles the oil pressure light and eml light start to flicker on and off together as it ticks over at lights etc. If i just give it a tiny bit of revs and take the idle speed up a fraction they go out.
My first thought was could it be oil pump - not being driven round fast enough as the engine idles or maybe just oil pressure switch - however i've changed this recently?
Oh also . . . handbrake cables snapped, any easy way to check which one has gone without whippin the drums off?
Any ideas anyone?
Cheers John
The most recent problem however is when the engines been running for bout an hour everytime the engine idles the oil pressure light and eml light start to flicker on and off together as it ticks over at lights etc. If i just give it a tiny bit of revs and take the idle speed up a fraction they go out.
My first thought was could it be oil pump - not being driven round fast enough as the engine idles or maybe just oil pressure switch - however i've changed this recently?
Oh also . . . handbrake cables snapped, any easy way to check which one has gone without whippin the drums off?
Any ideas anyone?
Cheers John
- PRICER
- CB-Uk User
- Posts: 3510
- Joined: Sun May 10, 2009 9:21 pm
- Location: ludlow shropshire
Re: CORSA 1.0 12v OIL PREESURE LIGHT AND EML
urrmmm first thing i would have said was oil sensor but if you have changed it then it cant be that, you sure you have enough oil in it and it cant be the oil pump spinning fast enough as thats on the cambelt so your engine wouldnt be running, and as for your handbrake just get underneath and pull on the cables but when your ordering them make sure you make note on which one you need, as ones long and ones short.
TURBO LAG IS JUST FOREPLAY
2.0 16v GSI SPORT TWIN WEBER 45'S AND KENT CAMS :]
2.0 16v GSI SPORT TWIN WEBER 45'S AND KENT CAMS :]
- c16se corsa
- CB-Uk User
- Posts: 271
- Joined: Thu Jan 27, 2011 3:29 pm
- Location: Pontefract
Re: CORSA 1.0 12v OIL PREESURE LIGHT AND EML
sounds daft but check your oil? ecotec's love it, but the pressure switches are a common fault with them, and for how mutch the cables cos its worth buying all brandnew and giving the guiders on the rear beam a good fettle
If its not bodged then its not "propper"
Bike carb project
http://forums.corsa-b.co.uk/viewtopic.php?f=81&t=19528
Bike carb project
http://forums.corsa-b.co.uk/viewtopic.php?f=81&t=19528
-
- CB-Uk User
- Posts: 111
- Joined: Sat Nov 20, 2010 4:00 pm
Re: CORSA 1.0 12v OIL PREESURE LIGHT AND EML
cheers for quick replies.
ive checked the oil and its actually slightly above max . . . i know this is not good but i've not let any out yet just really getting to the end of my patience with this motor.
just noticed i think ive nicked the wire on oil pressure switch from where ive changed timing chain - reason i didnt mention timing chain being changed is this fault was happening quite a while before. i know these switches are quite notorious for breaking just wondering if it could have gone again - its not a genuine vaux.
ive checked the oil and its actually slightly above max . . . i know this is not good but i've not let any out yet just really getting to the end of my patience with this motor.
just noticed i think ive nicked the wire on oil pressure switch from where ive changed timing chain - reason i didnt mention timing chain being changed is this fault was happening quite a while before. i know these switches are quite notorious for breaking just wondering if it could have gone again - its not a genuine vaux.
-
- CB-Uk User
- Posts: 111
- Joined: Sat Nov 20, 2010 4:00 pm
Re: CORSA 1.0 12v OIL PREESURE LIGHT AND EML
was thinking pump cause of the lights going out when i increase the revs just a tiny bit
- c16se corsa
- CB-Uk User
- Posts: 271
- Joined: Thu Jan 27, 2011 3:29 pm
- Location: Pontefract
Re: CORSA 1.0 12v OIL PREESURE LIGHT AND EML
the pressure switch work on a switched earth so if it the wire was broken it wouldent come on, i dont really think there is much quality difference between a spurious one and a genuine but there not over expensive to change if its a faulty unit
If its not bodged then its not "propper"
Bike carb project
http://forums.corsa-b.co.uk/viewtopic.php?f=81&t=19528
Bike carb project
http://forums.corsa-b.co.uk/viewtopic.php?f=81&t=19528
- c16se corsa
- CB-Uk User
- Posts: 271
- Joined: Thu Jan 27, 2011 3:29 pm
- Location: Pontefract
Re: CORSA 1.0 12v OIL PREESURE LIGHT AND EML
when i have had any oil light issues its been the switch apart from the xe that died a deathoctane41 wrote:was thinking pump cause of the lights going out when i increase the revs just a tiny bit
If its not bodged then its not "propper"
Bike carb project
http://forums.corsa-b.co.uk/viewtopic.php?f=81&t=19528
Bike carb project
http://forums.corsa-b.co.uk/viewtopic.php?f=81&t=19528
-
- CB-Uk User
- Posts: 111
- Joined: Sat Nov 20, 2010 4:00 pm
Re: CORSA 1.0 12v OIL PREESURE LIGHT AND EML
yeah i know there only cheap so i'll be gettin one anyway just so its somet to rule out if it doesnt sort it.
engine seems to be running totally fine just think its somet that shouldnt be ignored.
engine seems to be running totally fine just think its somet that shouldnt be ignored.
- c16se corsa
- CB-Uk User
- Posts: 271
- Joined: Thu Jan 27, 2011 3:29 pm
- Location: Pontefract
Re: CORSA 1.0 12v OIL PREESURE LIGHT AND EML
after my 2nd sensor on the xe i just ignored it i thought it was a dodgy sensor that i was getting off my supplier but sadly it wasnt after the big poooof on the m62
If its not bodged then its not "propper"
Bike carb project
http://forums.corsa-b.co.uk/viewtopic.php?f=81&t=19528
Bike carb project
http://forums.corsa-b.co.uk/viewtopic.php?f=81&t=19528
- PRICER
- CB-Uk User
- Posts: 3510
- Joined: Sun May 10, 2009 9:21 pm
- Location: ludlow shropshire
Re: CORSA 1.0 12v OIL PREESURE LIGHT AND EML
haha bita bad luck, and thats when you wiped your bearings and crank i guess,
TURBO LAG IS JUST FOREPLAY
2.0 16v GSI SPORT TWIN WEBER 45'S AND KENT CAMS :]
2.0 16v GSI SPORT TWIN WEBER 45'S AND KENT CAMS :]
- c16se corsa
- CB-Uk User
- Posts: 271
- Joined: Thu Jan 27, 2011 3:29 pm
- Location: Pontefract
Re: CORSA 1.0 12v OIL PREESURE LIGHT AND EML
me being ignorant a driving like a c**k probably, number 3 rod ended up doing a disapering act so i now need a crank ive got the rest
If its not bodged then its not "propper"
Bike carb project
http://forums.corsa-b.co.uk/viewtopic.php?f=81&t=19528
Bike carb project
http://forums.corsa-b.co.uk/viewtopic.php?f=81&t=19528
-
- CB-Uk User
- Posts: 111
- Joined: Sat Nov 20, 2010 4:00 pm
Re: CORSA 1.0 12v OIL PREESURE LIGHT AND EML
just had iot out then and a loud ticking has developed which increases with engine speed.
sounds like its coming from a valve on inlet cam??
sounds like its coming from a valve on inlet cam??
- c16se corsa
- CB-Uk User
- Posts: 271
- Joined: Thu Jan 27, 2011 3:29 pm
- Location: Pontefract
Re: CORSA 1.0 12v OIL PREESURE LIGHT AND EML
they are a very rattley engine but its mainly the timing chain tensioners that are the culprit with there infamous durability you could fit a new one from vaux and 500 mile down the road it decides to weaken and let the chain rattle, but then again it could be a lifter you never know i would try some fresh oil maybe a thicker grade or a bottle of whyns stop smoke
If its not bodged then its not "propper"
Bike carb project
http://forums.corsa-b.co.uk/viewtopic.php?f=81&t=19528
Bike carb project
http://forums.corsa-b.co.uk/viewtopic.php?f=81&t=19528
-
- CB-Uk User
- Posts: 111
- Joined: Sat Nov 20, 2010 4:00 pm
Re: CORSA 1.0 12v OIL PREESURE LIGHT AND EML
aye i know it was the hydraulic tensioner that had gone on it so i changed the whole thing while i had it apart.
i put 15w40 part synthetic instead of 10w40 cause of it bein a bit rattly. gonna just try gettin a new oil pressure switch for the price they cost anyway.
oh and had a look at handbrake today and its passenger side thats snapped, i think thats the short one?
cheers for the help guys.
i put 15w40 part synthetic instead of 10w40 cause of it bein a bit rattly. gonna just try gettin a new oil pressure switch for the price they cost anyway.
oh and had a look at handbrake today and its passenger side thats snapped, i think thats the short one?
cheers for the help guys.
- c16se corsa
- CB-Uk User
- Posts: 271
- Joined: Thu Jan 27, 2011 3:29 pm
- Location: Pontefract
Re: CORSA 1.0 12v OIL PREESURE LIGHT AND EML
no short one is the drivers side mate, and i forgot to mention about the eml whoever has done work on this car of before you has got to have wired it to the oil light for it to come on and on simutaniously
If its not bodged then its not "propper"
Bike carb project
http://forums.corsa-b.co.uk/viewtopic.php?f=81&t=19528
Bike carb project
http://forums.corsa-b.co.uk/viewtopic.php?f=81&t=19528