any one no the best way to tole arches not using a arch roller
like beating them out with with a hammer
need my arches rolling because my wheels are 7j wide and the have rubbed the plastic of on the rear now its down to bare metal and it digs into the tire any help guys
arch rolling
Moderator: Octane2097
-
coleman0113
- CB-Uk Newbie
- Posts: 18
- Joined: Sat Sep 17, 2011 7:05 pm
- Location: leeds
-
PRICER
- CB-Uk User
- Posts: 3510
- Joined: Sun May 10, 2009 9:21 pm
- Location: ludlow shropshire
Re: arch rolling
yea take the plastic arch off and get adjustable spanner and bend the metal lip outwards not inwards then just give it a tap with a hammer and re-place your plastic arch, you'l be suprised how 'flat' you can get the standard arches to go, here's my old car tucking 17's but i did narrow the rear beam to hub spacer... but yea anythings possible 
this was with just bending out the lip, you can just make it out,
and here is after i narrowed the rear beam and how much further i could 'tuck' i never drove on these even tho i spend so long making them fit...
this was with just bending out the lip, you can just make it out,
and here is after i narrowed the rear beam and how much further i could 'tuck' i never drove on these even tho i spend so long making them fit...
TURBO LAG IS JUST FOREPLAY
2.0 16v GSI SPORT TWIN WEBER 45'S AND KENT CAMS :]
2.0 16v GSI SPORT TWIN WEBER 45'S AND KENT CAMS :]
-
coleman0113
- CB-Uk Newbie
- Posts: 18
- Joined: Sat Sep 17, 2011 7:05 pm
- Location: leeds
Re: arch rolling
that looks O_o sweet bud aha
and i have ats cups on my 5 door
and i took the arch of today and give it a couple of taps in the arch put back on and the plastics new the door wnt go back on do i need to beat it alot more or is it just the lip i focus on (y)
and i have ats cups on my 5 door
and i took the arch of today and give it a couple of taps in the arch put back on and the plastics new the door wnt go back on do i need to beat it alot more or is it just the lip i focus on (y)