i have connected the easy bits up then now i have a problem...
i have connected the 4 injector's
temp sender to dash
water temp
crank shaft
air flow (not done but obz)
dizzy
coil
amplfier
so the problem is
i have the TPS sensor left
and a sliver/grey tub with some pipes one,
the TPS is 3 pin but i only have 2 pin plugs left
i have a plug left by the dash temp sender,
and a plug in the middle of the injector's
if anyone has any idea's?
heres a picture of what i have ( i had to disconnect the water temp so i could bring it in one picture)
