Brocade 2.0 16v

[l6tbm]

Thats looking mint mate, Cant wait to see it in there

[Jamie1991]

cheers lads will be in sunday, just hope everything goes well and it runs without problems

[rsi-dan]

good luck mate hope its all up running sweet sunday

[Jamie1991]

fitted in the engine today! done quite alot which im happy about, but got some problems, have a massive fuel leak at the rail and also getting no spark, which i believe now to be crank sensor, so going try one of them first. here's only pic i got anyways

[tychogsi]

well it's in so your on your way! keep up the good work.

[scorpiotn1]

fitted in the engine today! done quite alot which im happy about, but got some problems, have a massive fuel leak at the rail and also getting no spark, which i believe now to be crank sensor, so going try one of them first. here's only pic i got anyways

Same issue with mine, one the injectors kept leaking and had to mess around with O Rings and i think i swapped 2 of the injectors over into different beds for a better fit.

[Jamie1991]

mine leaked at the end of the rail. can unbolt the end of the rail on mine and i think they nremoved end when they did chroming and its upset seal so probs just needs a new seal. just ordered crank sensor from autovaux, was £52 so fairly expensive but at least i get it tomorrow morning

[paige1992]

looking good matey! Hope u sort that leak tho :/

[c16se corsa]

mine leaked at the end of the rail. can unbolt the end of the rail on mine and i think they nremoved end when they did chroming and its upset seal so probs just needs a new seal. just ordered crank sensor from autovaux, was £52 so fairly expensive but at least i get it tomorrow morning

autovaux is only down the road from me , if you need any valver bits ive got mashings of them including a few crank senors!lol

[Jamie1991]

still no joy after new crank sensor. aint got clue now why no spark

[PRICER]

I could do with a crank sensor for my LET dude

[Jamie1991]

ring autovaux, or there abit cheaper on ebay, but autovaux are genuine bosch ones... also cant see me sorting this out, think i may have to get and auto-electrican as ive tried pretty much everything, going to give another go 2mra if no luck i give up

[c16se corsa]

I could do with a crank sensor for my LET dude

ive got a few spare

[c16se corsa]

ring autovaux, or there abit cheaper on ebay, but autovaux are genuine bosch ones... also cant see me sorting this out, think i may have to get and auto-electrican as ive tried pretty much everything, going to give another go 2mra if no luck i give up

if you get mega stuck mate ive got a loom and ecu with all sensors for the later engine so it would be on dis and not dizzy, what havent you gone over and checked ? wires on the right sides on the coil? have you got the wiring right for the ecu in regards to the swiched live ect?

[Jamie1991]

yeah mate, sure all wired in correct and yeah hooked up switched live a tested and it goes out with ignition off and comes on when its on so thats wired right. it came out of a running corsa so most of loom was done, all i done is changed connecter joints and soldered wires instead and wired that plug on so could plug in into corsa loom