My car door was open all day the battery went flat. Removed it, Charged it, Put it back in.
Went to turn the key, Just kept turning over and over and over. Realised that I'd taken the transponder out of the key, put it back in, Turned key, engine started then cut out after a few seconds.
Now it will turn over but cut out every time after a couple of seconds.
There is also no throttle , pressing down to get some revs does nothing.
I've done an error test and got these.
P1526
P1481
P0115
P1405
P0100
Any ideas on what will solve this issue? Quite annoying seeing as its my new car and haven't even driven it yet..
Also the spanner light is on at first until it turns over then it goes, then a few seconds and it cuts out.
It starts every time but cuts out seconds later, Got someone coming round sometime this weekend with a code scanner so it might pick something up which the pedal test doesn't.
What does the immobiliser cut out? I can still hear the fuel pump when it dies.
Also seen that the clocks are a common problem with this, I've pushed them in quite hard and the problem is still there.
Copied all my replies from another thread on the corsa-c forum. I had no luck there.
Corsa C SXI 1.2 Starting Issue
Moderator: Octane2097
-
- CB-Uk User
- Posts: 64
- Joined: Mon Jul 13, 2009 12:13 pm
-
- CB-Uk Newbie
- Posts: 12
- Joined: Thu Apr 10, 2008 12:35 pm
Re: Corsa C SXI 1.2 Starting Issue
These are what I found by looking around...
P1526 Throttle Position Adaption Error C-09
P1481 Fan Relay 1 Circuit High C-34
P0115 Engine Coolant Temperature Circuit High Input C-11
P0100 Mass or volume air flow circuit high input C-10
http://www.bargainspares.com/vauxhall-e ... ira-omega/
P1526 Throttle Position Adaption Error C-09
P1481 Fan Relay 1 Circuit High C-34
P0115 Engine Coolant Temperature Circuit High Input C-11
P0100 Mass or volume air flow circuit high input C-10
http://www.bargainspares.com/vauxhall-e ... ira-omega/
-
- CB-Uk User
- Posts: 64
- Joined: Mon Jul 13, 2009 12:13 pm
Re: Corsa C SXI 1.2 Starting Issue
Thanks for your help, Got a friend to come round with his diagnostics machine, cleared the codes and its running.