detailing

[rsi-dan]

Anyone know how I can get my Gsi seats looking like new and smelly better as there hanging and have a horrid musty smell

been told to buy the following

Karcher WD 2.2 Wet and Dry Vac
a good interior shampoo
stiff interior brush
microfiber cloths

has any any other advise idea's ext

[johnny]

Harkus would be the man to ask,

All i use a foam from.a can.out of a pound shop or halfords interior stuff because it smells really nice

[andy w]

Lmao i used that car plan valet foam from asda for £3 just because i am a bit of a cheap skate lmao

[Harkus]

Harkus would be the man to ask

Your to kind pal :p

I'm a professional Valeter / Detailer with over 13 years experience so know what know talking about here.

So you can wet and vac your seats with a number if chemicals how ever this is one consuming and a real pain in the ars, the wet and vac machines are expensive to purchase.

Chemical wise there's nout wrong with with auto smart chemicals when it comes to this. Get your self some Brisk nap low foam, do about 3/4 brisk an half warm water, spray the chemical on to the seats and suck out, repeat process until clean

Or... If you have access to a compressor get your awl a device called a "tornado mix half brisk and half G101, spray on to seats using scrubbing brush attached to end of tornado and simply spray and scrub for around 5 mins a seat, allow to dry and boom done.

Either way is wet affective pal it depends how much time, access to equipment and passions you have. Hope this help

[rsi-dan]

Sweet so a wet n dry vac some brisk foam and loads of time is all i need want them looking mint tbh

Sent from my GT-I9100 using Tapatalk 2

[andy w]

Ya gotta put pics up before and after to show how they cane up

[Harkus]

Sweet so a wet n dry vac some brisk foam and loads of time is all i need want them looking mint tbh

Yes mate that's depending on how bad they are shouldn't take you more than an hour, make sure you do all the seat other wise it will dry patchy with marks and will need re doing.

So say you do the base then do all the base, of you do the backs do all the back including sides an tops, try not to get it on the windows other wise you'll hafta clean them to, wipe over the plastics after your done to .

Did these today on a C-max using a tornado

[Harkus]

Here's a link to my FB Page there's loads more pics on there drop a like on it to .

https://www.facebook.com/ValeAutoDetailing

[Harkus]

Here's a link to my FB Page there's loads more pics on there drop a like on it to .

https://www.facebook.com/ValeAutoDetailing

[rsi-dan]

Nice cheers mate

Sent from my GT-I9100 using Tapatalk 2

[Harkus]

No worries pal hope all this helps .

[Harkus]

Tornado pic for you pal .

[johnny]

what was used on the yellow mx5 that had all the bubbles on it? is it any good? where do i get it?

[Harkus]

Auto smart wash and wax pal, and nothin but wind (that's free) haha

[rsi-dan]

I dont have an air compresure would i be best with a wet vac

Sent from my GT-I9100 using Tapatalk 2