Illuminated visors

[stanc3w0rks]

Hi, ordering a pair of illuminated calibra visors today and just wondering how hard it is to fit them? I know i wire them to the live on the interior light, (is that red or green?) But should i cut the connectors off the wores on the visors? Also can i join the wires of the visors together and then to the interior light. Should i remove the roof lining? Any help is greatly appreciated thanks

Sent from my GT-I9100 using Tapatalk

[raymod]

ive just done this on my car

are you getting the loom with the visors if so this is what i did

1.take the interior light out unclip both wires RED is the live one
2.fit the visors including running the loom either side of the car (headlining pull it down a little at the front enough to feed the wire across)
3. Dont forget to clip the loom in at the visor too
4. The visor loom should now be in the middle of the car there will be a earth wire and a femaile spade connector
5.This is how i did it get a little wire then i got a snap lock connector what you attach to the interior light live. then with your spare bit of wire that goes into the snap lock connector too. put a spade connector on the other end of the loose wire fit to the sunvisor loom. attach the earth there is a hole up there to do this.
6. check to see if the lights come on.

walla all done clip everything back in place job done

[raymod]

ps if you get stuck ill pop my light back out and take a pic but you should be ok

[stanc3w0rks]

Cheers thanks ill put up a pic of the ones im getting and you cansee the connectors on them

Sent from my Ascend G300 using Tapatalk

[stanc3w0rks]

I was thinking i could cut off the connectors and run abit of extra wire, but there are two wires on each visor and i dont know where to run the other one to

Sent from my Ascend G300 using Tapatalk

[raymod]

ah you havnt got the car loom bit with them have you mine did thats what i gave you the info for above lol

erm what ive seen on other sites yeah you need to cut the connectors off the visors and feed a wire to them on each visor

live/earth on both visors

[stanc3w0rks]

Oh so live to the red interior light wire and earth to the grey one?:)

Sent from my GT-I9100 using Tapatalk

[raymod]

heres how this guy did it this is were i got it from dude

http://www.corsasport.co.uk/board/viewt ... tid=364767

[stanc3w0rks]

Thanks a mil should have the visors on thursday then can update my project thread

Sent from my GT-I9100 using Tapatalk

[raymod]

its a neat little cheap mod buddy