my rio verde project

[andy w]

Haha cheers dom this light was sitting in a shed lol but the finnished product will be clean and cheers johhny

[Blackie_No1]

Looks well

[Blackie_No1]

Like it mate should work if it that dark of a green

Blackie-No1 check what side you have as I broken one of my spare if you have the other side to mine can have my other to make a set

It's the drivers side mate, just rescued it from the bin lol

[andy w]

Cheers blackie just wondering now how to make the clear plastic lense on the indicator back clear not the manky yellowish colour it is

[rsi-dan]

Like it mate should work if it that dark of a green

Blackie-No1 check what side you have as I broken one of my spare if you have the other side to mine can have my other to make a set

It's the drivers side mate, just rescued it from the bin lol

Mine make your full set as its passanger

Sent from my GT-I9505 using Tapatalk

[johnny]

Just take the yellow bit out and theres no need for a clear lens:) that's what I do anyway

[Blackie_No1]

No I mean it's the drivers side I broke

[andy w]

Ahh cheers johnny wasn't sure if it had to be in or not so that will stay out then lol

[Blackie_No1]

You mention that you cut the glue but by bit, did you remover the plastic lip so that you could get at the glue?

[andy w]

No mate just bent the lip so i cud get the blade in when it had been in the oven after a few mins

[Blackie_No1]

Ah right

[andy w]

So quick question how long does it take for tigar seal to harden ??

[johnny]

I normally leave it over night to be safe but it should be set after an hour

[andy w]

Sound will leave it a few hours by a radiator then

[andy w]

So decided to make the depos in black as the green didn't look right when mocked it against the car so need wait a few hours for the tigar seal to harden then put them on the car so will pic them up later or tomoz for u guys