Gaskets

[rsi-dan]

So i got my gesket kit yesurday but no clue as to where these go



Sent from my GT-I9505 using Tapatalk

[Blackie_No1]

The 8 at the left are valve stem oil seals, the two on the right are camshaft oil seals, the one to the right of the camshaft seals is manifold to down pipe, don't know what the other two are

[andy w]

Cud they be water pump seals at all?

[rsi-dan]

So this is correct

[andy w]

The other two cud be the oil pump seals

[rsi-dan]

so the cam shaft seals have now been changed

were are the oil stem seals ? do I have to compress the springs and remover them tiny collets to gain accesse to them ?

[Blackie_No1]

Soz, could be wrong about cam seals.

Yea you need to take the valves out iirc to replace seals

[rsi-dan]

Ornage is is fitted just need to know were the black one gos above it

Sent from my GT-I9505 using Tapatalk

[Blackie_No1]

At the other end of cam?

[rsi-dan]

Just my coil pack that end no gaskets at all that end ?

[Blackie_No1]

Is there a centre bearing on that cam?

[rsi-dan]

Unsure How would i know ?

Sent from my GT-I9505 using Tapatalk

[Blackie_No1]

When you look at the cam is it fixed in place just at the ends or is there a "clamp" at the middle too?

[rsi-dan]

Cam is just fixed in place no "clamp "

Sent from my GT-I9505 using Tapatalk

[Blackie_No1]

Ok, it's possible it's for a kit that tailors to that engines predecessor that uses a distributor at the end of the cam