ya kinda reading my mind mate haha looks kinda plain without any therejohnny wrote:Looks cracking mate:) once the doors sprayed you should get some wind deflectors they look so good on the more door
my rio verde project
- andy w
- CB-Uk User
- Posts: 4279
- Joined: Wed Sep 18, 2013 10:32 am
- Location: newcastle-under-lyme
Re: my rio verde project
If it ain't green and black send it back
- JamieTee_
- CB-Uk User
- Posts: 1850
- Joined: Wed Feb 26, 2014 6:03 pm
- Location: Manchester
- Contact:
Re: my rio verde project
oh is it haha, look better once it's sprayed up thenandy w wrote:JamieTee_ wrote:Was about to ask you that actually, be sweet once it's the right colour
Sent from my fingers on my screen
Haha that's actually what Río Verde looks like without lacquer sprayed in top but don't worry mate wont like that much longer
Sent from my iPad using Tapatalk
Using Tapatalk
- andy w
- CB-Uk User
- Posts: 4279
- Joined: Wed Sep 18, 2013 10:32 am
- Location: newcastle-under-lyme
Re: my rio verde project
So not much of any updates on the more door atm but its running rich atm does any one no if there is a fuel/air mixture aduster at all or how to resolve this issue this payday im getting new plugs as mine are coming to there end but the running rich issue is getting a little worse lately that any help wud be greatfull guys
If it ain't green and black send it back
- Teastick
- CB-Uk User
- Posts: 435
- Joined: Wed Jul 24, 2013 9:03 pm
Re: my rio verde project
If you reset your ecu by leaving the battery unplugged for a few hours it might sort it out as it re maps itself again. I read up about this somewhere before and it worked for me
When you start the car first time leave it to idle it will idle high for a while. Its important you wait untill your idle has settled before you drive it
Once its settled go for a five mile drive and use the rev range.
Hope this helps
When you start the car first time leave it to idle it will idle high for a while. Its important you wait untill your idle has settled before you drive it
Once its settled go for a five mile drive and use the rev range.
Hope this helps
- andy w
- CB-Uk User
- Posts: 4279
- Joined: Wed Sep 18, 2013 10:32 am
- Location: newcastle-under-lyme
Re: my rio verde project
Have already reset the ecu mate and thinking its related to the eml that ive always had comin on tbh
If it ain't green and black send it back
- Teastick
- CB-Uk User
- Posts: 435
- Joined: Wed Jul 24, 2013 9:03 pm
Re: my rio verde project
Fair enough mate check all your sensors / clean them
- andy w
- CB-Uk User
- Posts: 4279
- Joined: Wed Sep 18, 2013 10:32 am
- Location: newcastle-under-lyme
Re: my rio verde project
Thinking might be the lamba/o2 is the problem so might try cleaning it if worst change it
If it ain't green and black send it back
- Teastick
- CB-Uk User
- Posts: 435
- Joined: Wed Jul 24, 2013 9:03 pm
Re: my rio verde project
How long has it been running rich?
- andy w
- CB-Uk User
- Posts: 4279
- Joined: Wed Sep 18, 2013 10:32 am
- Location: newcastle-under-lyme
Re: my rio verde project
For a while mate cleaned the plugs when it failed mot as they were sooted up bad so it just scrapped the emissions second time round its always since i first bought it had slight over fueling as my fuel return is less than others i no been told change coolant temp sensor aswell
If it ain't green and black send it back
- andy w
- CB-Uk User
- Posts: 4279
- Joined: Wed Sep 18, 2013 10:32 am
- Location: newcastle-under-lyme
Re: my rio verde project
Not much of an update but replaced the cts and plugs to see if the eml stops turning on and sort the running rich problem my little more door has
If it ain't green and black send it back
- johnny
- Senior Moderator
- Posts: 4875
- Joined: Sun Jul 08, 2012 4:26 am
- Location: Donegal,Ireland
Re: my rio verde project
Is yours coilpack or the dizzy version? Could be advanced a tooth or two?
Is it backfireing?
Is it backfireing?
If it doesn't fit,
force it,
If it breaks,
It needed replacing anyway
force it,
If it breaks,
It needed replacing anyway
- andy w
- CB-Uk User
- Posts: 4279
- Joined: Wed Sep 18, 2013 10:32 am
- Location: newcastle-under-lyme
- andy w
- CB-Uk User
- Posts: 4279
- Joined: Wed Sep 18, 2013 10:32 am
- Location: newcastle-under-lyme
Re: my rio verde project
And no its not back firing what.so ever
If it ain't green and black send it back
- johnny
- Senior Moderator
- Posts: 4875
- Joined: Sun Jul 08, 2012 4:26 am
- Location: Donegal,Ireland
Re: my rio verde project
It's weird that it's not backfireing
What state were the old plugs in
What state were the old plugs in
If it doesn't fit,
force it,
If it breaks,
It needed replacing anyway
force it,
If it breaks,
It needed replacing anyway
- andy w
- CB-Uk User
- Posts: 4279
- Joined: Wed Sep 18, 2013 10:32 am
- Location: newcastle-under-lyme
Re: my rio verde project
Sooted up mate i cleaned them just b4 the retest on my mot the car fired up like usual with the old ones in but it misfired now and then so i may aswell keep em as spares when i ave driven the car for about an hour i will see if the eml comes on agen like it normally does if not then ive finally cured it lol if it does back to the drawing board haha am thinking cud be the o2 sensor is comin to its end but thort id start with the cheapest first
If it ain't green and black send it back