my rio verde project

For New & Continuing Projects Only.
NOT for past projects or questions.
Post Reply
User avatar
andy w
CB-Uk User
Posts: 4279
Joined: Wed Sep 18, 2013 10:32 am
Location: newcastle-under-lyme

Re: my rio verde project

Post by andy w »

johnny wrote:Looks cracking mate:) once the doors sprayed you should get some wind deflectors :P they look so good on the more door
ya kinda reading my mind mate haha looks kinda plain without any there
If it ain't green and black send it back :D
User avatar
JamieTee_
CB-Uk User
Posts: 1850
Joined: Wed Feb 26, 2014 6:03 pm
Location: Manchester
Contact:

Re: my rio verde project

Post by JamieTee_ »

andy w wrote:
JamieTee_ wrote:Was about to ask you that actually, be sweet once it's the right colour ;)


Sent from my fingers on my screen ;)

Haha that's actually what Río Verde looks like without lacquer sprayed in top but don't worry mate wont like that much longer :lol:
oh is it haha, look better once it's sprayed up then :)


Sent from my iPad using Tapatalk
Using Tapatalk
User avatar
andy w
CB-Uk User
Posts: 4279
Joined: Wed Sep 18, 2013 10:32 am
Location: newcastle-under-lyme

Re: my rio verde project

Post by andy w »

So not much of any updates on the more door atm but its running rich atm does any one no if there is a fuel/air mixture aduster at all or how to resolve this issue this payday im getting new plugs as mine are coming to there end but the running rich issue is getting a little worse lately that any help wud be greatfull guys
If it ain't green and black send it back :D
User avatar
Teastick
CB-Uk User
Posts: 435
Joined: Wed Jul 24, 2013 9:03 pm

Re: my rio verde project

Post by Teastick »

If you reset your ecu by leaving the battery unplugged for a few hours it might sort it out as it re maps itself again. I read up about this somewhere before and it worked for me

When you start the car first time leave it to idle it will idle high for a while. Its important you wait untill your idle has settled before you drive it
Once its settled go for a five mile drive and use the rev range.

Hope this helps
User avatar
andy w
CB-Uk User
Posts: 4279
Joined: Wed Sep 18, 2013 10:32 am
Location: newcastle-under-lyme

Re: my rio verde project

Post by andy w »

Have already reset the ecu mate and thinking its related to the eml that ive always had comin on tbh
If it ain't green and black send it back :D
User avatar
Teastick
CB-Uk User
Posts: 435
Joined: Wed Jul 24, 2013 9:03 pm

Re: my rio verde project

Post by Teastick »

Fair enough mate check all your sensors / clean them
User avatar
andy w
CB-Uk User
Posts: 4279
Joined: Wed Sep 18, 2013 10:32 am
Location: newcastle-under-lyme

Re: my rio verde project

Post by andy w »

Thinking might be the lamba/o2 is the problem so might try cleaning it if worst change it
If it ain't green and black send it back :D
User avatar
Teastick
CB-Uk User
Posts: 435
Joined: Wed Jul 24, 2013 9:03 pm

Re: my rio verde project

Post by Teastick »

How long has it been running rich?
User avatar
andy w
CB-Uk User
Posts: 4279
Joined: Wed Sep 18, 2013 10:32 am
Location: newcastle-under-lyme

Re: my rio verde project

Post by andy w »

For a while mate cleaned the plugs when it failed mot as they were sooted up bad so it just scrapped the emissions second time round its always since i first bought it had slight over fueling as my fuel return is less than others i no been told change coolant temp sensor aswell
If it ain't green and black send it back :D
User avatar
andy w
CB-Uk User
Posts: 4279
Joined: Wed Sep 18, 2013 10:32 am
Location: newcastle-under-lyme

Re: my rio verde project

Post by andy w »

Not much of an update but replaced the cts and plugs to see if the eml stops turning on and sort the running rich problem my little more door has
If it ain't green and black send it back :D
User avatar
johnny
Senior Moderator
Posts: 4875
Joined: Sun Jul 08, 2012 4:26 am
Location: Donegal,Ireland

Re: my rio verde project

Post by johnny »

Is yours coilpack or the dizzy version? Could be advanced a tooth or two?

Is it backfireing?
If it doesn't fit,
force it,
If it breaks,
It needed replacing anyway :thumbs:
User avatar
andy w
CB-Uk User
Posts: 4279
Joined: Wed Sep 18, 2013 10:32 am
Location: newcastle-under-lyme

Re: my rio verde project

Post by andy w »

Mines a coil pack mate
If it ain't green and black send it back :D
User avatar
andy w
CB-Uk User
Posts: 4279
Joined: Wed Sep 18, 2013 10:32 am
Location: newcastle-under-lyme

Re: my rio verde project

Post by andy w »

And no its not back firing what.so ever
If it ain't green and black send it back :D
User avatar
johnny
Senior Moderator
Posts: 4875
Joined: Sun Jul 08, 2012 4:26 am
Location: Donegal,Ireland

Re: my rio verde project

Post by johnny »

It's weird that it's not backfireing

What state were the old plugs in
If it doesn't fit,
force it,
If it breaks,
It needed replacing anyway :thumbs:
User avatar
andy w
CB-Uk User
Posts: 4279
Joined: Wed Sep 18, 2013 10:32 am
Location: newcastle-under-lyme

Re: my rio verde project

Post by andy w »

Sooted up mate i cleaned them just b4 the retest on my mot the car fired up like usual with the old ones in but it misfired now and then so i may aswell keep em as spares when i ave driven the car for about an hour i will see if the eml comes on agen like it normally does if not then ive finally cured it lol if it does back to the drawing board haha am thinking cud be the o2 sensor is comin to its end but thort id start with the cheapest first
If it ain't green and black send it back :D
Post Reply