Hi everyone,
The timing chain in the Z12xe engine was interrupted,
Although the compression ratio of 10.1:1
Valves Collided whit the pistons - And some valaes got twisted..
I started todismantle the head, I'll Upload Photos of the process,
Z12XE Cylinder Head Opening
Moderator: Octane2097
- Aditi
- CB-Uk Newbie
- Posts: 17
- Joined: Mon Jul 21, 2014 8:54 am
Re: Z12XE Cylinder Head Opening
Camshaft seem a bid rusty!|
Valve cover face looks burnt down oil sludge..
[FONT=Arial Black]Cylinder Head Opening[/FONT]
There is a dedicated device for catching the wave brackets
There is something the measurements of survivors locked the latch and allows him to move
Valve cover face looks burnt down oil sludge..
[FONT=Arial Black]Cylinder Head Opening[/FONT]
There is a dedicated device for catching the wave brackets
There is something the measurements of survivors locked the latch and allows him to move
- Aditi
- CB-Uk Newbie
- Posts: 17
- Joined: Mon Jul 21, 2014 8:54 am
Re: Z12XE Cylinder Head Opening
Water crossings that appear really not good!
Defective valves
2 of exhaust
2 of the air inlet
Their different angles, they do not come back into place until the end of the entire movement.
- Aditi
- CB-Uk Newbie
- Posts: 17
- Joined: Mon Jul 21, 2014 8:54 am
Re: Z12XE Cylinder Head Opening
I will be happy to know what is the role of the part?
- Aditi
- CB-Uk Newbie
- Posts: 17
- Joined: Mon Jul 21, 2014 8:54 am
Re: Z12XE Cylinder Head Opening
I will be happy to know what is the role of the part?
Screws below were taken at high pressure..
- Aditi
- CB-Uk Newbie
- Posts: 17
- Joined: Mon Jul 21, 2014 8:54 am
Re: Z12XE Cylinder Head Opening
There is someone ho can give me the measurements of the screw mounting that Locks the crank-shaft ?
Length ?
Screw appears at Number 2
Also the tool that reinforce the Camshaft.. (appears at no 1):
Length ?
Screw appears at Number 2
Also the tool that reinforce the Camshaft.. (appears at no 1):
- johnny
- Senior Moderator
- Posts: 4875
- Joined: Sun Jul 08, 2012 4:26 am
- Location: Donegal,Ireland
Re: Z12XE Cylinder Head Opening
Should all be included in a locking kit from eBay or any autofactors
If it doesn't fit,
force it,
If it breaks,
It needed replacing anyway
force it,
If it breaks,
It needed replacing anyway
- Aditi
- CB-Uk Newbie
- Posts: 17
- Joined: Mon Jul 21, 2014 8:54 am
Re: Z12XE Cylinder Head Opening
Blocking the EGR Valve,
is the EGR valve passages blocker Offered by eBay Appropriate ?
its Leaves one open passage.. For the Cooling Fluid
has Someone tried it ?
It is important to block the air duct enters the valve?
is the EGR valve passages blocker Offered by eBay Appropriate ?
its Leaves one open passage.. For the Cooling Fluid
has Someone tried it ?
It is important to block the air duct enters the valve?