First Car (1.2 16v Envoy)
-
- CB-Uk User
- Posts: 417
- Joined: Wed Jun 04, 2014 9:21 am
Re: First Car (1.2 16v Envoy)
Went and got a couple bargains today! A little tool box just for my screwdrivers and pliers and what not for the boot so they're not rolling about like usual, toolbox = £1 and a 40 piece socket set = £5
I'm wanting to take out my front and back seats later in order to give the car a full clean out, how easy is it to do this?
Sent from my iPhone using Tapatalk
I'm wanting to take out my front and back seats later in order to give the car a full clean out, how easy is it to do this?
Sent from my iPhone using Tapatalk
- Barraclough
- CB-Uk User
- Posts: 2414
- Joined: Fri Sep 27, 2013 7:15 pm
- Location: Manchester
Re: First Car (1.2 16v Envoy)
2 bolts at the back of the front seats then tilt forward and pull out, after putting the red fork in the seat belt tensioner. The back bench is just 2 small screws underneif. The back rests have a bolt on the side when you tilt forward and another under the plastic trim on the other side.
-
- CB-Uk User
- Posts: 417
- Joined: Wed Jun 04, 2014 9:21 am
Re: First Car (1.2 16v Envoy)
Ahh cool thanks! I'll see how it goes then, I understood all of that other than the red fork part aha
Sent from my iPhone using Tapatalk
Sent from my iPhone using Tapatalk
- Barraclough
- CB-Uk User
- Posts: 2414
- Joined: Fri Sep 27, 2013 7:15 pm
- Location: Manchester
Re: First Car (1.2 16v Envoy)
It's pretty simple. Take the plastic trim off next to the seat and it will have a sticker explaining. Basically push the red fork in the slot before removing the seat.
-
- CB-Uk User
- Posts: 417
- Joined: Wed Jun 04, 2014 9:21 am
Re: First Car (1.2 16v Envoy)
Ahh fair enough I'll have a go tomorrow hopefully! So I've seen a spoiler for sale at £10 it needs primer and paint and apparently has a few chips, but it's half an hour away, what do you all reckon?
Sent from my iPhone using Tapatalk
Sent from my iPhone using Tapatalk
- johnny
- Senior Moderator
- Posts: 4875
- Joined: Sun Jul 08, 2012 4:26 am
- Location: Donegal,Ireland
Re: First Car (1.2 16v Envoy)
Depends on condition really mate, if there very small chips some filler primer might do it but if it needs work it could cost 50-70 quid for a bodyshop to sort
They sell in good condition for about £30, Danny on thecorsa is selling an arden blue spoiler I think
They sell in good condition for about £30, Danny on thecorsa is selling an arden blue spoiler I think
If it doesn't fit,
force it,
If it breaks,
It needed replacing anyway
force it,
If it breaks,
It needed replacing anyway
-
- CB-Uk User
- Posts: 417
- Joined: Wed Jun 04, 2014 9:21 am
Re: First Car (1.2 16v Envoy)
Prepare for a picture overload!
So got to work on getting the seats out today to give the car a proper vac!
Passenger side seat out! I only detached them from the runner as it seemed a bit easier aha
Recaro?! :O
Then I decided to take out the centre piece as it was really simple, and my god it was horrid around the gear stick!
Nice build up of tobacco and ash
Drivers side seat was much harder to get out due to the height adjuster!
More tobacco
And this was behind the rear bench, I couldn't get it all off as I didn't have the correct screwdriver
Nice amount of dog hairs! Must be like 4 years old or more too these hairs!
After a little brush and vac!
And now the clean car
And then got it all back together
I know that no one will really see the difference, but for my knowledge that it's all clean and that the slight smell of fags and dog may go now it makes me feel much better haha!
My little bit of decoration!
I got all three of these for free!
Saw this in asda earlier, BEST UMBRELLA EVER!
Ooh and good news! I got more pictures of that spoiler today, and I managed to haggle the price down to a fiver! Going to pick it up tomorrow! Plus it doesn't actually look all that bad
It won't be getting any spray for a couple months but it will eventually all be done by me, hopefully it'll turn out like my handles did, but knowing I have one ready is awesome!
Sent from my iPhone using Tapatalk
So got to work on getting the seats out today to give the car a proper vac!
Passenger side seat out! I only detached them from the runner as it seemed a bit easier aha
Recaro?! :O
Then I decided to take out the centre piece as it was really simple, and my god it was horrid around the gear stick!
Nice build up of tobacco and ash
Drivers side seat was much harder to get out due to the height adjuster!
More tobacco
And this was behind the rear bench, I couldn't get it all off as I didn't have the correct screwdriver
Nice amount of dog hairs! Must be like 4 years old or more too these hairs!
After a little brush and vac!
And now the clean car
And then got it all back together
I know that no one will really see the difference, but for my knowledge that it's all clean and that the slight smell of fags and dog may go now it makes me feel much better haha!
My little bit of decoration!
I got all three of these for free!
Saw this in asda earlier, BEST UMBRELLA EVER!
Ooh and good news! I got more pictures of that spoiler today, and I managed to haggle the price down to a fiver! Going to pick it up tomorrow! Plus it doesn't actually look all that bad
It won't be getting any spray for a couple months but it will eventually all be done by me, hopefully it'll turn out like my handles did, but knowing I have one ready is awesome!
Sent from my iPhone using Tapatalk
-
- CB-Uk User
- Posts: 417
- Joined: Wed Jun 04, 2014 9:21 am
Re: First Car (1.2 16v Envoy)
Yeah! I'm now £5 lighter but I have myself a spoiler
The condition is great tbh, just a few scratches and scrapes in the primer he previously put on
Epic win
Sent from my iPhone using Tapatalk
The condition is great tbh, just a few scratches and scrapes in the primer he previously put on
Epic win
Sent from my iPhone using Tapatalk
-
- CB-Uk User
- Posts: 417
- Joined: Wed Jun 04, 2014 9:21 am
Re: First Car (1.2 16v Envoy)
Gave the car a good clean today! First one in a month!
Before:
Back to black makes a huuuuge difference!
After:
Ahh much better driving around a clean and fresh car!
Also PROBLEM SOLVED! My front bumper had a bit of movement in it due to it being all cracked and broke but a clip/screw was broke so I replaced it with a very professional item!
Nailed it...
Any ideas on why the drivers side of my bonnet doesn't close correctly?
The other side is aligned perfectly but this side is always like this, I can even push it down and it pops back up
Sent from my iPhone using Tapatalk
Before:
Back to black makes a huuuuge difference!
After:
Ahh much better driving around a clean and fresh car!
Also PROBLEM SOLVED! My front bumper had a bit of movement in it due to it being all cracked and broke but a clip/screw was broke so I replaced it with a very professional item!
Nailed it...
Any ideas on why the drivers side of my bonnet doesn't close correctly?
The other side is aligned perfectly but this side is always like this, I can even push it down and it pops back up
Sent from my iPhone using Tapatalk
- stanc3w0rks
- CB-Uk User
- Posts: 3303
- Joined: Tue Feb 18, 2014 4:08 pm
- Location: mayo, ireland
Re: First Car (1.2 16v Envoy)
So the cable tie worked lol. My bonnet does the same man they are a pig to line up
-
- CB-Uk User
- Posts: 417
- Joined: Wed Jun 04, 2014 9:21 am
Re: First Car (1.2 16v Envoy)
Yes! The cable tie is doing a great job no more squeaky front bumper aha and ahh fair enough then I've hit a dilemma!
I don't know whether to get a badgless slat grill or to do something like this to mine:
Sent from my iPhone using Tapatalk
I don't know whether to get a badgless slat grill or to do something like this to mine:
Sent from my iPhone using Tapatalk
- stanc3w0rks
- CB-Uk User
- Posts: 3303
- Joined: Tue Feb 18, 2014 4:08 pm
- Location: mayo, ireland
Re: First Car (1.2 16v Envoy)
Someone on here probably knows about the bonnet. I cant see most of your pics including that last one
-
- CB-Uk User
- Posts: 417
- Joined: Wed Jun 04, 2014 9:21 am
Re: First Car (1.2 16v Envoy)
Oh really? That's not gooooood! Erm hold on
Sent from my iPhone using Tapatalk
Sent from my iPhone using Tapatalk
-
- CB-Uk User
- Posts: 417
- Joined: Wed Jun 04, 2014 9:21 am
Re: First Car (1.2 16v Envoy)
Mmm looks so clean and awesome
Sent from my iPhone using Tapatalk
Sent from my iPhone using Tapatalk
- stanc3w0rks
- CB-Uk User
- Posts: 3303
- Joined: Tue Feb 18, 2014 4:08 pm
- Location: mayo, ireland
Re: First Car (1.2 16v Envoy)
Looks good. What grill are you thinking of?