93 corsa merit help

noddy_2004 · Post by **noddy_2004** » Wed Jul 13, 2005 6:35 pm

Hi everyone can someone help me out. I want to put central locking and electric windows in my corsa. Now i`ve looked at the posts on here and have checked the doors but have only the two speaker wires but if i look at the fuse box the wires are there waiting for the fuses to be put in. Now am i looking at wiring the whole lot in or is it a bit simpler by changing part of the loom thanks for any help

punkheadgray · Post by **punkheadgray** » Wed Jul 13, 2005 8:55 pm

maybe the wires only go as far as the plug on the door, and the part inside the door hasnt been fitted??
thats what i reckon, i bought a four door kit cheap (was Â£20 on clearence) fitted it to my old nova without any problems, just cut the other two actautors off.
was just an \'electric actuator pump thing\' (dunno the proper word) that went on the drivers side \'bar\' that connects to the door pin, when you put the key in, the pump moves down and does same on opposite side,
i spose you could check for continuity between pins at the door not being used, and spares in the fuse box? do you have a multimeter?
as for leccy windows a kit from an old corsa at the scrappy is the best bet

noddy_2004 · Post by **noddy_2004** » Wed Jul 13, 2005 9:36 pm

The wires dont go in the rubber gromit at the a post, so i was wondering if it was just a case of changing the floor loom at a conecter some wear in the car. i havent checked to see if there live in the fuse box yet will do that tomorrow after its mot, if someone has a wiring diagram for the corsa it will be a big help to me.

punkheadgray · Post by **punkheadgray** » Wed Jul 13, 2005 9:48 pm

id just a run a wire from the back of the fuse box to the a pillar plug connection then mate, much easier thenlaying a new loom idve thought

as for schematics, i can scan and email you wahts in the haynes manual if you want? not sure it\'d help that much tho

noddy_2004 · Post by **noddy_2004** » Wed Jul 13, 2005 9:49 pm

that will be a big help thanks

punkheadgray · Post by **punkheadgray** » Wed Jul 13, 2005 10:23 pm

need your email address matey, its not in your contact details. not sure the schematic will tell you much.

noddy_2004 · Post by **noddy_2004** » Wed Jul 13, 2005 10:46 pm

sorry its noddy_2004@msn.com if i have it aleast i`ll have an idea of how it all goes in thanks