spoiler

morgan100 · Post by **morgan100** » Tue Oct 18, 2005 3:11 pm

Im looking to get a spoiler for my corsa b but i dont want a GSI one. Want something like thew MS design one. Just for the top, like a mk4 fiesta spoiler. Any ideas where to get as the MS design one is well expensive IMO. Any ideas where to get one similar cheaper?

Anyone know how much work it would take to make the mk4 fiesta one fit??

Joff · Post by **Joff** » Tue Oct 18, 2005 3:28 pm

I\'ve got a damaged MS Design one for sale. It\'s snapped cleanly in half so looks bad but would be fairly straightforward for a bodyshop to support inside and smooth over.

The rest of the spoiler is intact.

gareth_towler · Post by **gareth_towler** » Tue Oct 18, 2005 3:34 pm

cud get AN irmishur one also but xpensive unless u look around alot

morgan100 · Post by **morgan100** » Tue Oct 18, 2005 6:15 pm

na, already had problems wit a broken spoiler, thnks nyway. Anyone else got any ideas??

CR41G · Post by **CR41G** » Sat Oct 22, 2005 5:03 pm

try www.potn.com

tom87 · Post by **tom87** » Sat Oct 22, 2005 6:11 pm

[quote=\"gareth_towler\"]cud get AN irmsher one also but xpensive unless u look around alot[/quote]

na there just the same as the gsi one but with an irmscher badge

, theres not really many spoiler on the market that look good for the corsa apart from the stock vauxhall one. steinmetz might make one but no doubt it will be stupidly overpriced. i know you say you dont want a gsi one but its probably your best bet tbh, cheap, good looking and good quality.

martint2k4 · Post by **martint2k4** » Sat Oct 22, 2005 9:24 pm

if you get the broken one, you might be able to drill 2 long holes down either side of it, and put 2 steel thin rods inside, then bond it together with resin or similar, then smooth it over with filler? may work

Joff · Post by **Joff** » Sun Oct 23, 2005 3:49 pm

[quote=\"martint2k4\"]if you get the broken one, you might be able to drill 2 long holes down either side of it, and put 2 steel thin rods inside, then bond it together with resin or similar, then smooth it over with filler? may work[/quote]

Yup, that\'s all it needs. Because it\'s an MS Designs spoiler, it\'s made from PU RIM which is stronger than fibreglass, so can be repaired easier.