Roof Lining

Automotive topics & discussion.
Post Reply
Dodgy Dave
CB-Uk User
Posts: 151
Joined: Thu Apr 07, 2005 7:17 pm
Location: Birmingham

Roof Lining

Post by Dodgy Dave »

how is the roof lining stuck to the roof, is it glued on or does it just stay up when all the pannels are in place
voodoo_jellybaby2k2
CB-Uk User
Posts: 216
Joined: Wed Jun 01, 2005 11:46 pm
Location: Darlington

Roof Lining

Post by voodoo_jellybaby2k2 »

Theres 3 bolts of some sort at the rear window. I only know this much due to mine not being there and the roof lining hanging down a tad.......

I think you have to remove all of the plastic interior that ends near the roof, i.e a-pillar plastics, b-pillar plastics etc etc etc, and even then i think theres still more bolts and poo u have to take out.

I have been told its an absolute f*ck on changing the roof lining, as my mate works on the combos and corsas every day as a mechanic/fitter, and he said hes had to change one once, and he\'s never done it since!

He told me its not too much of a job to get the lining off.....but he said when you put a new one in, its a badger as you have to line everything up before you start putting the bolts in, he said it takes a few off you to do it, and its a f*ck on

Hope that helps! :thumbs:
Dodgy Dave
CB-Uk User
Posts: 151
Joined: Thu Apr 07, 2005 7:17 pm
Location: Birmingham

Roof Lining

Post by Dodgy Dave »

cheers for that, but its a bit to late as half of it is hanging down and it needs re-trimming any way
User avatar
Mad Doc
CB-Uk User
Posts: 166
Joined: Sun Oct 23, 2005 7:46 pm
Location: Cirencester

Roof Lining

Post by Mad Doc »

I re-trimmed mine. putting it back in was a pain!
"got any coke!?" "No, try the white car!!!!" TIMMEH!!!!!!!
spud
CB-Uk Newbie
Posts: 35
Joined: Wed Mar 16, 2005 10:08 pm
Location: Grimsby

Roof Lining

Post by spud »

Whilst you\'re discussing head linings, will it be a big job to lower a section of the head lining enough to put in a CB antennae in the middle of the roof? I would just need it low enough to tighten up the mount and wire up the co-ax!! and then refit the headlining.

Without you can think of somewhere else to stick it? (Ooh -err!! Please keep answers clean :o )

Cheers,

Spud.
Post Reply