lil hooligan

[offplot]

What make of cage is it adam ?
Where do the rear legs fit to ?

[Chrex]

I think the cage is weischens? Is a bloody good one anyways! Meets the floor down at the back corners, literally, as far back as you can get into the car.

It looks uber solid!

[Adam-D]

bonnet is now fitted properly

weekend job, sort the wiring out so it starts and stops as it should and may move under its own power

[jar_jar89]

i hated gettin my bonnet on square, still isnt quite, but hey, at least it sits flush now

[Adam-D]

mine isnt perfect its about 5mm on the piss. but its pinned down. and solid. so good enuff

[jar_jar89]

yeah...the gap on the right is like 3-4mm wider than on the left on mine. but i have to do this so the bonnet catch works properly cos for sum reason when the bonnet lined up propa the catch isnt! but nvm....can barely notice it

[Adam-D]

first off, im sore. not stopped all weekend pretty much.
took the exhaust off w-l and fitted it to chrex/chris's car.
then took his exhaust and fitted it to mine, my decta is still blowing at the uni join so i gotta fabricate something for that.

right, heres what i got done,
fitted bonnet catch's they work now,
exhaust as said,
haeneses went in.
dials "had murder getting all the bits working, and i do mean all of them every single function had to be modyfy'd to work"

started off with speedo "electronic" then dash lights. indicator, flash, fog, battery, oil pressure, engine temp, then rev meter.
not all looms have a rev wire in the loom as i found out and then made one for it.

made the loom for the ecu to run, and found the dizzy plug and dizzy both suspect so thats the next job. along with a new handbrake switch.

connected gear linkage

removed damaged plastic arch's

made up a dash panel it isnt finished yet but needs a few more switch's etc

fitted 2 of the three pulls for fire and electrics

fitted the mirrors

on the plus side, it now moves under its own power.

still got loads of wireing to do, and tons of those little jobs that seem to take forever.

i only got a few photo's at the end of today. been to busy to take them as i went.

bonnet


pulls


dash panel "not finished"


lots of wireing to do


harneses


dials

[iToMo x]

Its getting there aint it keep it up

[Adam-D]

small update from working in the rain etc today but i did magae to do this....



http://www.youtube.com/watch?v=Rd6nNb7yfko

[danthemann]

i love this car lol

[Chrex]

getting there ad, so very close.

I am gonna have to make a metal plate up for my ash tray hole, that will be my switch panel mounting place. Good work though lately

[jar_jar89]

u done a well neat job wit hthem bonnet catches! i was thinkin bout usina 306 air vent from the bonnet to put in a cold feed for induction kit when i get one. what u use to cut the bonnet with? look in nice btw...u aimin to take it to pvs?

[PaulW]

u aimin to take it to pvs?

It will be at PVS...

[jar_jar89]

NICE! u takin for 1/4mile only or gonna be having a go on the handling course in it?

[Adam-D]

both

no idea what it'll do, never driven it in 2 years, ive built it form the ground up