bonnet l.e.d's

[danthemann]

il try and get a pic tmro..or cud u try drawin sumit on paint that mite help? lol...im good at most stuff..just reli dont get it wen it comes to wiring lol

[roperstun]

yea ill have a go mate wnt be much good though.

it red and black from the switch and red and black on the washers?

[danthemann]

i cudnt tell ya lol...from the bonnet led's theres 4 wires..a red n black from each washer jet...

but i havnt looked at the wiring behind the switch..but it controls about 6 led's in the footwells.

[roperstun]

right its not very good so dnt laugh

basically you cut the black and red wire goin to the switch from the power source on you neons and put the red in a connector block and the black in a sperate block and then put the washer jet into the right colour block.
basically u jst cuttin the power cables and puttin them into a conector block and then your jst adding the washer jets into the blocks so they are fed from the power. you can either do this befor or after the switch if you want them at the same time do it after the switch



hope it helps a bit ill explain an other day better if u like cuz thts poo cuz im tired

[MattyB]

Like it!

Dan have you got your footwell neons wired into a switch already?

[danthemann]

yeh i have matty...

so with them connector things..will i need like 2 of em..coz above somewhere jar_jar sed u just cut off how many little block bits u need?

[jar_jar89]

lol..essentially ur just gonna make poisitive and neagative feeds y split using the little blocks as connectors. use one for each cable e.g. positive cable into one side of one the blocks, then two positive feeds out the other side of the same block. one for washers one for footwell neons. u dont really have to do the negative cables as roperstun was suggesting as u can just earth em to the chassis, or if ur feelin brave the negative terminal on the battery and they should work fine. then as long as the switch for the footwell neons is on the positive cable feed u will be able to turn em on/off to ur desire.

[danthemann]

im still confused lol.iv got the right connector now.found it i nthe shed..its the same as in the pic u showed me..and has 2 of the little block bits.should that be enough?i might just wait til pvs and get somoeone to do it for me lol

[RenRenRen]

Yeah, that's all you need. Should look like this when you're done (wire from the switch on left, wires out to your lights on the right).

[danthemann]

thats a very big help..but what about the wires from my footwell led's??

[RenRenRen]

Same side as the bonnet leds, matching the red & black wires again

[danthemann]

lol..thanks mate.made it seem so simple

now once iv figured out where the wires from the switch are il be alrite.