Corsa-B.uk - Vauxhall, Opel and Holden Corsa B Owners Club

gay
how fast it go mate?

haha! its got loads of torque!! and iv had 80 out of it

you need a bigger sledge lol
http://www.youtube.com/watch?v=tlEeVXyqzzY thats us at college having ago pulling the tractor sledge

yea haha iv seen that before on there, and well mines only a series so it aint that heavy, but tbf we have got a BIG sledge, here's some photos from the last time we had it out the other weekend,

few photos of my new tyres insa turbo saharas 235 85 16

looks good mate

i still think its gay haha , btw i bumped your inlet up on sport

PRICER wrote:haha yerr it would, but i bet it'd be a bastard to paint think i'l stick to what colours hamerite have in they're range

did my chassie in red oxide looked nice mot time and was a lot easier to keep clean rather than underseal which in my opinion holds the crap on and just rots it out more think i paid £20 for 5 gallon at a farm sale lol was a few years ago now mind lol

PRICER wrote:here is my layout of the front end air filter on the left, radiator in the centre and my intercooler on the right



and iv done a brake upgrade on the front aswell, gone from standard brakes to series 3 v8 brakes, should make it stop a bit better



and iv mounted my spare wheel in the back aswell

I put the series 2 front on mine but put spot lights in instead of the standard lights looked nice with them in the wings too top job you done mate

PRICER wrote:still got LOADS to do haha i have thought about painting it but i dunno if i will lol

did mine in kingfisher blue.....really stood out will post a pic if i got one i can upload on computer

yea that would be cool, i know of a series 2 land rover parked up iv been pestering about buying it then i would swap my whole front end and the chassis number and make it tax exempt save on the robbing tax man, im not going to spray mine as im wanting it to be used for off road etc so scratches and odd dent i dont mind, this is more of my play toy as iv got a series 1 land rover in the shed thats my baby

an update of the landrover, spotlights fitted on the roof, and fitted new heater plugs today she starts LOADS better now, a little present for her for winter and a whippy aerial for the CB radio when i get it installed,



and i also siliconed in the floor pans and put more bolts in to pull them up and try and fill in some of the holes to stop the wind getting in so the heater has a chance of working lol got new high and low lever gaiter and new handbrake gaiter coming aswell so they should be here this week sometime so that will also stop alot of cold air coming into the cab, and ordered some rear mud flaps aswell, and some headlight and tail light mesh covers, and a radiator muff to try and get the engine warmer in the winter

put some longer front spring shackles on Wednesday to lift the front up level with the back looks LOADS better now i'l have to get some photos of it, also its made my suspension be able to travel alot more so its nicer to drive and softer

well after driving this around for over a year as my other vehicle due to the corsa being off the road for pretty much most of it, its had ALOT of stick and done alot of miles, even went on an off roading weekend with a few mates earlier in the year around wales, did like 400 miles in one weekend, my back was killing by the time we got back but a hell of a weekend,
but just a summary,
the gearbox went not long after that, so had to source another gearbox,
and broke a rear half shaft, t
hen the front wheel bearing collapsed and was sitting on the half shaft then that snapped and the wheel came off.
and now the gearbox has gone again! so im building an R380 gearbox from a discovery and converting it to fit my 200TDI gearbox with a ultra short bell housing.
and through all this water it got me thinking i need to upgrade the axles. so iv bought some 300TDI discovery axles so they're ALOT wider than what iv got now so i'l be getting discs all round then aswell as having defender arches so it'l look proper wide

and here are a few photos of what i mentioned,

oh had some fun and made a door card,



shapped rear shaft in the diff, that i had to get out with hammer and chisel.



made a big centre console with switches and a volt gauge, got a water temp and oil temp to go in there aswell at some point,



photo of when the wheel came off,



then made a winch bumper but still need to finish it and buy and install the winch but im saving my money just yet and re-building it first



my new gearbox in pieces waiting on couple of bearings then can build it back up, but still yet to order them .