Page 10 of 40

Re: corsa

Posted: Thu Feb 10, 2011 2:55 am
by M4RSH4LL
:L well atm i cant take pics because things are either getting painted or posted ... so its a waiting game :D

Re: corsa

Posted: Thu Feb 10, 2011 3:15 am
by Spicy-McHaggis
lol!
im trying to figure out a hinge for the screen so that i can twist it towards driver side! think i found one that will allow me to twist both ways :) within limits though and the screen drops down and folds away snug :D

Re: corsa

Posted: Fri Feb 11, 2011 6:05 pm
by M4RSH4LL
got few things in post :D

the rest of long botls came :D so myby change alloys over tomorrow

Image
got this becasue old one broken :D

Image

got a strut :D good thing looks well bad thing look below!

Image

half sticker missing (wasnt one ebay pic ffs tho i no a guy who will make me one

aslo its dented wtf!
Image

any1 any ideas on a cheap fix? so it cosmeticly looks fine?

Re: corsa

Posted: Fri Feb 11, 2011 6:16 pm
by Spicy-McHaggis
possibly the previous owner had to dent it to make that xtra 1/4 of an inch soace for something else

Re: corsa

Posted: Fri Feb 11, 2011 6:21 pm
by jordyp
did the brace already have a dent? tbh I would take that sparco sticker off. I dunno if using a slide hammer would take any the strength out of it or
no

Re: corsa

Posted: Fri Feb 11, 2011 6:33 pm
by M4RSH4LL
like what? wud be near nothing in engine too far over tbh its near batry meh fcuk it i reckon if i fll it in then get it wraped in something it will look well ... + aye sparco off myby replace with vauxhall idk yet

Re: corsa

Posted: Fri Feb 11, 2011 6:41 pm
by Spicy-McHaggis
true that!

have it wrapped in same color as the car :)

Re: corsa

Posted: Fri Feb 11, 2011 6:51 pm
by M4RSH4LL
was thinking carbon ;) (yes imma chav) no no geting red calipars so stay red i think stand out a bit better
also went and tested it it is bend for a ryellow cap on a bottel with yellow cap

Image


(i know it needs a good clean ! but ive no time atm ) :D + lazy
up near top ITS SUCH A TIGHT FIT!!

ps if i undo these to attach it it wont fcuk up anything them bolts are holding on will it?

Image

Re: corsa

Posted: Fri Feb 11, 2011 6:52 pm
by Spicy-McHaggis
should be straight bol onto them bolts there yes

Re: corsa

Posted: Fri Feb 11, 2011 6:56 pm
by M4RSH4LL
if i break my car i blame u ... :D

Re: corsa

Posted: Fri Feb 11, 2011 7:03 pm
by Spicy-McHaggis
M4RSH4LL wrote:if i break my car i blame u ... :D
lol ok :lol:

Oh AND!

http://www.cartuningtips.com/43-fitting ... o-your-car

Re: corsa

Posted: Fri Feb 11, 2011 7:05 pm
by M4RSH4LL
yay now ill defo do it wrong! im hopeless with cars :D

Re: corsa

Posted: Fri Feb 11, 2011 7:07 pm
by Spicy-McHaggis
M4RSH4LL wrote:yay now ill defo do it wrong! im hopeless with cars :D
its easy dude, undo one side... place brace over bolts and tie nuts onto bots :lol: repeat otherside

Re: corsa

Posted: Fri Feb 11, 2011 7:11 pm
by M4RSH4LL
give it a go tomorrow :D if its not too rainy

Re: corsa

Posted: Fri Feb 11, 2011 7:14 pm
by Spicy-McHaggis
and if you REALLY struggling lol grab ur TV at both sides and get urself centre and knock head repeatedly against the tv! :lol: you cannot mess this one up mate its like fitting cone filter :P

its not like ur doing headgaskets or anything close to that