Page 20 of 121
Re: new project :D
Posted: Sat Dec 25, 2010 8:08 am
by Big C
it looking lush mate
P.S. can i hav your dog??????
Re: new project :D
Posted: Sat Dec 25, 2010 4:07 pm
by PRICER
haha never he's ours
Re: new project :D
Posted: Sun Jan 09, 2011 3:58 pm
by PRICER
small update, can anyone tell what these are?
Re: new project :D
Posted: Sun Jan 09, 2011 4:09 pm
by PRICER
thats the base done
Re: new project :D
Posted: Sun Jan 09, 2011 5:28 pm
by bluecorsab
sorry to say this but they wont work
Re: new project :D
Posted: Sun Jan 09, 2011 5:35 pm
by PRICER
haha why?
Re: new project :D
Posted: Sun Jan 09, 2011 5:39 pm
by bluecorsab
the element needs to be on the other side of the foam, all your doing there is heating the bottom of the foam and not the top where you want the heat, there not powerful enough to generate the heat needed to go through about 2 maybe 3 inches of foam to the top
Re: new project :D
Posted: Sun Jan 09, 2011 5:41 pm
by PRICER
no that is the top
that fabric you see is the seat cover it just flops down onto the seat pad.
Re: new project :D
Posted: Sun Jan 09, 2011 5:46 pm
by bluecorsab
didnt look at the first pic, was reffering to the other one, looks like you put the element on the bottom
Re: new project :D
Posted: Sun Jan 09, 2011 5:48 pm
by PRICER
nooooo wasnt hard to strip the fabric off, iv taken the seat out and striped it down removed fabric covers, installed the base and back seat pads, and re-asembled one seat in about an hour ish, just got to find the electrics under the carpet now one of these next nights after work then try and wire them up
Re: new project :D
Posted: Sun Jan 09, 2011 6:28 pm
by duncanpound
bluecorsab wrote:didnt look at the first pic, was reffering to the other one, looks like you put the element on the bottom
thats just the seat spring bits mate that hold the foam up
the pad elements are all internal in the pads
iv got a set too
Re: new project :D
Posted: Sun Jan 09, 2011 10:55 pm
by PRICER
yep, hopefully going to have a go at wiring them in on saturday, if all goes well
Re: new project :D
Posted: Sun Jan 09, 2011 11:29 pm
by bluecorsab
duncanpound wrote:thats just the seat spring bits mate that hold the foam up
i do know, i aint thick
Re: new project :D
Posted: Thu Jan 13, 2011 11:28 pm
by PRICER
should have a nice small update for you all if things go well 2moro afternoon
Re: new project :D
Posted: Thu Jan 13, 2011 11:31 pm
by duncanpound
and ill have an update on the silver blade
i hope haha