Corsa-B.uk - Vauxhall, Opel and Holden Corsa B Owners Club

Hey, been a long time since I posted here!

Im having some issues with my beloved corsa.

For some time now ive been experiencing an intermittent mis fire, which occurs at low revs, in any gear. Ive replaced the spark plugs & HT leads with new ones and the problem persists

Im also averaging 25/26 MPG on it, its a 1.2 8v with 58k on the clock.

Any suggestions guys?

when you changed your plugs what were they like as in

filth if so what like if u get me

Ive been doing some thinking and this mis firing problem started just after I had a full service done in march, where they changed the spark plugs.

Im wondering now if maybe they have replaced them with the wrong ones?

Im gonna go into haulfrauds and get them to look up the ones that should be in it and check them.

I have a Haynes manual in front of me...misfires occur because:

-Fuel Filter Choked
-Fuel Pump Faulty, or delivery pressure low
-Fuel tank vent blocked, or fuel pipes restricted
-Vacuum leak at the fuel injection unit/throttle body, inlet manifold or associated hoses
-Worn, faulty or incorrectly-gapped spark plugs
-Faulty spark plug HT leads
-Distributor cap cracked or tracking internally - where applicable
-Faulty ignition coil or DIS module
-Uneven or low cylinder compressions
-Fuel injection system fault

I'd be checking the condition of your spark plugs, then the HT leads for any white residue indicating wear & tear. Maybe get some new plugs? If not, check the distributor caps.

oops..sorry, didn't read the post above. Yeah I'd be checking the model of plugs they're replaced yours with...what engine do you have? DOHC? SOHC? what litre? and what year?

Good luck

Think its a SOHC

1.2 8v 1997 R plate.

exactly same car as mine.

Check the plugs are the correct model for your car and the HT leads + distributor caps are not loose.

So had a got at taking the EGR Valve off, but the bolts that hold it in place are fast on, and rusty, so was having no joy gettin grip on them!

Any suggestions?

use some WD40 and a wire brush

clean it all up thn some derv might loosen it up