Page 1 of 1

central locking

Posted: Wed Dec 17, 2008 4:52 pm
by LilLew
--------------------------------------------------------------------------------

1997 Corsa B 1.2 LS 3 door
i have installed a thrid party central locking kit but it does not work i have looked at the tutorial on here but i am unable to see the pictures so i can not have a proper look any help

So far
Connected the door motors driver and passenger
Wired loom from battery to door motors

there are still two wires that i have not connected because i dont know were they go it is a brown wire and a white wire i think they might be remote wires but bugga know what for
there where no instruction when i brought this kit

any suggests will help

Re: central locking

Posted: Wed Dec 17, 2008 8:40 pm
by RenRenRen
Does it look like this? If so the spare brown/white cables are for connecting it to an alarm system if you have one.

If that is the one, let me know & I'll upload a copy of the installation instructions for you.

Re: central locking

Posted: Thu Dec 18, 2008 11:00 am
by LilLew
take away the two fobs and that is my kit key entry only

Re: central locking

Posted: Thu Dec 18, 2008 10:32 pm
by RenRenRen
Scanned it in, then noticed it's actually on the manufacturer's site here :P

The non-remote version is the Hawk CDL-04, is the inline fuse on the red wire before the control unit still good? Only the 5 wire (master) motor can activate the others, so make sure you're testing with that one rather than the 2 wire motors as you'll get nothing from them.

Re: central locking

Posted: Fri Dec 19, 2008 12:45 am
by LilLew
my two front door motors are five wire each and yes the fuse is fine