4 guage power cable wiring

Post anything electrical or ICE here. ie, upgrading your stereo, or removing looms etc.

Moderator: Octane2097

Post Reply
EazyDuz
CB-Uk Newbie
Posts: 1
Joined: Tue May 12, 2009 8:35 pm

4 guage power cable wiring

Post by EazyDuz »

I fit my sub today with 4awg power cable down the passenger side trim. The trim near the front sticks up now revealing a gap between the trim and inside the trim where the cable itself is. Its about 5mm gap. What should i do about this?
I thought about running it under the carpets but would rather not if possible as it would take ages. Doesnt seem to be enough room down the sills for 4 guage though, i think its mostly where the pillar between the front and rear door is where the sills go narrower and make it harder to keep the wire in. Im worried about water getting in say when i wash my car or it rains and then the water getting in the trim and around the wires.
inliner_04
CB-Uk User
Posts: 145
Joined: Tue Feb 24, 2009 10:02 pm
Location: Bromley/Orpington, SE London

Re: 4 guage power cable wiring

Post by inliner_04 »

mine doesnt stick up at all, just poke it behind anything you can, you can feed it behind all trim and it comes out just before the boot begins under the rear cards
kona1991
CB-Uk User
Posts: 215
Joined: Fri Nov 21, 2008 5:28 pm
Location: Bedford

Re: 4 guage power cable wiring

Post by kona1991 »

ive got the power cable going down the drivers side and it fits fine.
Thats not a dent.... its an aerodynamic mod :P
Post Reply