Page 1 of 1
Radio decoding and fitting new headunit.
Posted: Sun Nov 29, 2009 5:12 pm
by Thomas
Hi all,
Thanks for the responces to the other posts.
Got my new headunit but the orginal radio is in safe mode (needs decoding) so i am now woundering if i have to get it decoded before i fit my new headunit or is it ok to fit my new head unit?
Thanks in avdvance.
Re: Radio decoding and fitting new headunit.
Posted: Sun Nov 29, 2009 5:46 pm
by roperstun
jst fit your new headunit
Re: Radio decoding and fitting new headunit.
Posted: Sun Nov 29, 2009 7:21 pm
by mobiius
Yeah, it's only the head unit which is coded, not your car.
Re: Radio decoding and fitting new headunit.
Posted: Sun Nov 29, 2009 7:21 pm
by Thomas
Ok thanks.
Where can i run the RCA cables in the dash boad for the headunit to amp in the boot?
Thanks Thomas
Re: Radio decoding and fitting new headunit.
Posted: Sun Nov 29, 2009 9:15 pm
by matty101
right this is what i did take the cables left out the back of the head unit, aroound the back of the self and down behind the kicker pannel (next to the front of the door). then along the bit of plastic trim at the bottom of the doors, you will have to see a little bit of the cable next the the back seat unless you wanna run it under the carpet, then loop the spare wire under the back seat and pop it out thoruogh the back of the seat and connect up