starting problem
Moderator: Octane2097
-
- CB-Uk Newbie
- Posts: 12
- Joined: Sat Jan 16, 2010 9:12 pm
starting problem
just bought 1999 corsa envoy 973cc and all is going well apart from one thing.after being out on a journey for any length of time,engine will not restart until it has completely cooled down.when this is happening,management light remains on whilst engine is turning over.after an hour or so engine starts first time and management light stays off.had cam sensor replaced but still the same.
just signed up to this forum so would greatly appreciate any replies.
thanx in advance
just signed up to this forum so would greatly appreciate any replies.
thanx in advance
- LesterPiglet1
- CB-Uk User
- Posts: 398
- Joined: Mon Jun 09, 2008 9:11 pm
- Location: Bangor, Norn Iron
Re: starting problem
Sounds like the idle control valve. This deals with cold starting and if it's stuck will be hard to start the car when warm. Try cleaning it first, if this doesn't help replace it.
http://forums.corsa-b.co.uk/viewtopic.php?f=105&t=13412
http://forums.corsa-b.co.uk/viewtopic.php?f=105&t=13412
-
- CB-Uk Newbie
- Posts: 12
- Joined: Sat Jan 16, 2010 9:12 pm
Re: starting problem
where do i find idle control valve
- matty101
- Senior Moderator
- Posts: 2961
- Joined: Thu May 28, 2009 8:54 pm
- Location: Hexham
Re: starting problem
if you mean where do you buy them,theres a alot of places do them any good parts shops, vauxhaul dealer although they will be pricey or theres vaious places online but u cud always try a scapyard first.
or if u mean where on the car have a look at the link below
http://forums.corsa-b.co.uk/viewtopic.php?f=105&t=13412
or if u mean where on the car have a look at the link below
http://forums.corsa-b.co.uk/viewtopic.php?f=105&t=13412
OFFICAL DVLA DATA:
1414 - corsa gsi's on the road in 2008.
735 - corsa gsi's currently on the road and 436 SORN
Basicly you would have to be a right tw*t to break one for parts
Thanks to everyone for an awsome weekend at pvs!
1414 - corsa gsi's on the road in 2008.
735 - corsa gsi's currently on the road and 436 SORN
Basicly you would have to be a right tw*t to break one for parts
Thanks to everyone for an awsome weekend at pvs!
-
- CB-Uk User
- Posts: 392
- Joined: Wed Sep 23, 2009 10:40 am
Re: starting problem
il tell ya exacly what that is crank shaft sensor 20 pound off ebay had the very exact problem its located just above the sum i think its an external torx screw all you do is undo th torx pull the sensor out, unclip the plug on it push it back into the hoe and do the bolt back up.100% positive mate
-
- CB-Uk Newbie
- Posts: 12
- Joined: Sat Jan 16, 2010 9:12 pm
Re: starting problem
thanks guys.ill try both these things out first and let you know how it goes.
-
- CB-Uk User
- Posts: 392
- Joined: Wed Sep 23, 2009 10:40 am
Re: starting problem
I Can insure you it will be the crank sensor
-
- CB-Uk User
- Posts: 392
- Joined: Wed Sep 23, 2009 10:40 am
Re: starting problem
I bet when you turn the key the engine turns over and over but doesn't fire
-
- CB-Uk Newbie
- Posts: 12
- Joined: Sat Jan 16, 2010 9:12 pm
Re: starting problem
yeah thats right.not until engine cools down
-
- CB-Uk Newbie
- Posts: 12
- Joined: Sat Jan 16, 2010 9:12 pm
Re: starting problem
seems to start ok though if you fire it up within 5 minutes of switching off.dont understand that 1
-
- CB-Uk Newbie
- Posts: 12
- Joined: Sat Jan 16, 2010 9:12 pm
Re: starting problem
is it possible to replace crank sensor without having access to a ramp
- LesterPiglet1
- CB-Uk User
- Posts: 398
- Joined: Mon Jun 09, 2008 9:11 pm
- Location: Bangor, Norn Iron
Re: starting problem
Yep, jack up drivers side of car and put in an axle stand.
- Octane2097
- Senior Moderator
- Posts: 2125
- Joined: Sun Jun 25, 2006 9:25 pm
- Location: Barnsley, South Yorkshire
Re: starting problem
already been said, but i had this problem,
crank sensor about £20 for a new one and half hour to fit
crank sensor about £20 for a new one and half hour to fit
Peugeot 207 Sport 1.6 VTI (120)
-
- CB-Uk Newbie
- Posts: 12
- Joined: Sat Jan 16, 2010 9:12 pm
Re: starting problem
thanks all.ill get onto it asap
-
- CB-Uk Newbie
- Posts: 12
- Joined: Sat Jan 16, 2010 9:12 pm
Re: starting problem
crank sensor replaced and evrything seems ok.thanks for the advice everyone