Page 1 of 1

dials not working

Posted: Wed Feb 03, 2010 4:59 pm
by miller 850
hi guys i have changed my engine to a 1.4 8v sri lump from a 1.2 8v, i have changed the dials over but the fuel gauge does not work and nor does the speedo and the fuel light is constantly on weather it is some thing to do with not installing the fuel pump and sender correctly im not sure, any ideas?

Re: dials not working

Posted: Wed Feb 03, 2010 6:22 pm
by dandadan
check the connection in the back of the clocks and make sure its in correct also was the float free moving on the pump

Re: dials not working

Posted: Wed Feb 03, 2010 6:30 pm
by miller 850
erm think the float was it worked on the car before

Re: dials not working

Posted: Wed Feb 03, 2010 6:32 pm
by LesterPiglet1
As far as I am aware the pumps are all the same so wouldn't need changed. Why were the clocks changed? This is where the fault lies most likely.

Re: dials not working

Posted: Wed Feb 03, 2010 6:35 pm
by miller 850
well i changed the engine with fuel pump so i changed the dials the rev counter works and the temp gauge

Re: dials not working

Posted: Wed Feb 03, 2010 6:37 pm
by LesterPiglet1
?? The fuel pump is in the petrol tank.

Re: dials not working

Posted: Wed Feb 03, 2010 6:49 pm
by miller 850
Yes?

Re: dials not working

Posted: Wed Feb 03, 2010 6:52 pm
by LesterPiglet1
I'm still wondering why you went to the bother.

Re: dials not working

Posted: Wed Feb 03, 2010 7:08 pm
by miller 850
the fuel pumps run at different pressures the 1.2 one was 0.7 bar and the 1.4 one is 3 bar

Re: dials not working

Posted: Wed Feb 03, 2010 7:09 pm
by LesterPiglet1
That's odd. Never seen anything about that in haynes. Must rescan it.

Re: dials not working

Posted: Wed Feb 03, 2010 8:26 pm
by miller 850
i checked it up on autodata before changing it so

Re: dials not working

Posted: Wed Feb 03, 2010 8:29 pm
by LesterPiglet1
Haynes must have missed that as there is no mention.
Is your speedo electric or mechanical?

Re: dials not working

Posted: Wed Feb 03, 2010 9:28 pm
by miller 850
its cable. im pretty sure both ends are plugged in propperly but im going to check but cant see y petrol gauge wont work

Re: dials not working

Posted: Wed Feb 03, 2010 11:54 pm
by LesterPiglet1
You need to check the sender unit in the tank as you have had it out.