Corsa-B.uk - Vauxhall, Opel and Holden Corsa B Owners Club

So i was looking around my engine today and was thinking about putting an induction kit in
but when i took the pannel filter out to look under
i have a manual air flow meter :@
could i just take it all out and take the red tube off the throttle body
and have a cone or do i just but cotton pannel filter which i really dont want to do?
thanks
chris

to fit an induction kit you usualy remove the airbox and piping the cone will usualy go on the end of the air duct that would connect to the airbox
like this: http://www.newdesignworld.com/img/data/ ... 300419.JPG
so it should be starting from top: Thottle body - duct - MAF- Cone
airbox can be discared (unless u play to refit later)

yeahh i know like that all need to go where
but on the origanal air box theres some like small red tube coming from the side of the air box and going into the throttle body do i just remove this?

just block the end up with a screw or bolt as long as its air tight

i have a 1.2 16v and put a shocking kit on sounded good but costed me a fair bit to get a new mas. so i got put back to standard i was thinking about getting a green induction kit but just woried about the mas.