Bonnet wont fit?

[Thomas]

Hi all,

Had my bonnet replaced a little while back and it wasent fit correctly (dont sit properly around headlights). Was not fitted by me but some stupid garage.

So i thought i will try and correct it but i am struggling any tips or ideas?

Cheers

[kie-1200sxi-shed]

should fit up easily , defoo a 2 man job to line it up correctly ( same size gap on each side ) if they are correct then maybe the problem is the bonnet itself ( bent or warped ) . also you will notice on the metel stud with a spring at the front in middle that you can adjust it in height (for it to sit higher or lower )

[Insumnier]

Its probably twisted then, i have the same problem
the worst part is i need two people to pop my bonnet
id say try and fit it your self

[simsy]

I have an easy solution to this problem. Just use a chainsaw and blowtourch with this mould provided below. Good luck!

[matty101]

lol u actually took the time to make that?................

u have way to much spare timelol

[kie-1200sxi-shed]

lmao hmmmmmm its amzing true work of art lol