Corsa-B.uk - Vauxhall, Opel and Holden Corsa B Owners Club

HI,
someone crashed into me while i was asleep woke up went out to find my car offside wing shortened
so i replaced the broken light, but cause the wings bent doesnt fit aswell with the bonnet, just wandering how i remove it as i shall replace it think i know but a few pics to show where all the bolts are and any other small bits i need to remove are would be nice
also looking to buy some small bits to improve the look/performance of my corsa if any one would like to message me with cheap bits for sale that would be nice thanks

Do you not have a Haynes manual for it? Those things are a godsend! If noone gets back to you later, ill have a flick through and see if it tells you how to do it - i know im using it soon to replace my rear drivers door after someone backed into it

Subliminal if you could have a quick look that would be great as i too need to replace my girlfriends front wing. are they welded or bolted on do you know???

cheers

On my 5Dr, it's bolted and not overly difficult to remove. Not sure if it's the same for the smaller 3Drs though.

ah.. hers is a 3dr. hopefully its bolted too. will make things sooooooo much easier

right then, "cough cough" i believe theirs three or four bolts under the bonnet, then open the door and theirs one at the top of the wing, and then theirs one on the sill and im pretty sure thats all their is. take all them out then give it a good yank with it being bent aswell it might be stuck somewhere.

PRICER wrote:right then, "cough cough" i believe theirs three or four bolts under the bonnet, then open the door and theirs one at the top of the wing, and then theirs one on the sill and im pretty sure thats all their is. take all them out then give it a good yank with it being bent aswell it might be stuck somewhere.

theres them 1's and then there is two behind the bumper

do wot i do when i'm not sure, a have a go on a 1 in ur local scrapyard

matty101 wrote:do wot i do when i'm not sure, a have a go on a 1 in ur local scrapyard

LMAO, I always do the same! It's like a heavy duty playground haha

popping down the scrappy is a Excellent idea nice one will be sure to get some practice in

so as theres bolts behide the bumper i would guess i would need to remove the bumper too??????

steve

for the bumper 1's, just take that corner off