torque settings for hub nut?
Moderator: Octane2097
-
delta_kid
- CB-Uk User
- Posts: 192
- Joined: Fri Feb 06, 2009 3:47 pm
- Location: High Wycombe
torque settings for hub nut?
torque setting for front hub nut.. or are they tapered?
-
maxlee
- CB-Uk Newbie
- Posts: 6
- Joined: Mon Apr 26, 2010 1:07 am
Re: torque settings for hub nut?
pressed bearings nut has a split pin that stops it from coming undone
-
delta_kid
- CB-Uk User
- Posts: 192
- Joined: Fri Feb 06, 2009 3:47 pm
- Location: High Wycombe
Re: torque settings for hub nut?
so they have to be tight then ?
-
maxlee
- CB-Uk Newbie
- Posts: 6
- Joined: Mon Apr 26, 2010 1:07 am
Re: torque settings for hub nut?
i did mine up with my small braker bar so tight but not crazy as in jumping up and down on the bar i would say
-
gonzo94
- CB-Uk User
- Posts: 171
- Joined: Sat Feb 21, 2009 9:23 pm
- Location: eltham,london
Re: torque settings for hub nut?
drive shaft retaining nut
stage 1 100nm/74lbf ft
stage 2 slaken nut completely
stage 3 20nm/15lbf ft
stage 4 30nm/22lbf ft
stage 1 100nm/74lbf ft
stage 2 slaken nut completely
stage 3 20nm/15lbf ft
stage 4 30nm/22lbf ft
crapper did'nt invent the toilet.