Page 1 of 1
torque settings for hub nut?
Posted: Sun Apr 25, 2010 4:56 pm
by delta_kid
torque setting for front hub nut.. or are they tapered?
Re: torque settings for hub nut?
Posted: Mon Apr 26, 2010 1:18 am
by maxlee
pressed bearings nut has a split pin that stops it from coming undone
Re: torque settings for hub nut?
Posted: Mon Apr 26, 2010 7:32 am
by delta_kid
so they have to be tight then ?
Re: torque settings for hub nut?
Posted: Mon Apr 26, 2010 8:44 am
by maxlee
i did mine up with my small braker bar so tight but not crazy as in jumping up and down on the bar i would say
Re: torque settings for hub nut?
Posted: Mon Apr 26, 2010 9:10 am
by gonzo94
drive shaft retaining nut
stage 1 100nm/74lbf ft
stage 2 slaken nut completely
stage 3 20nm/15lbf ft
stage 4 30nm/22lbf ft