Page 1 of 1

clutch

Posted: Mon Apr 26, 2010 8:55 pm
by redtop c
just changed the clutch in my c20xe put evrything back together went to start the car and it seems like its stuck in gear any ideas cheers

Re: clutch

Posted: Mon Apr 26, 2010 8:59 pm
by titlit
its because you ay gotta clue ginge lmao

Re: clutch

Posted: Mon Apr 26, 2010 9:01 pm
by kie-1200sxi-shed
your gears are out .

jack up the car front and put axel stands under
open the bonnet and on the gear selctor tower "sticky up bit on the gear box" on the part thats facing the bulkhead there is a little round plastic plug.
pull it out
then get a 4.5mm drill bit and insert it into the hole while twisting the gear linkage "get a mate to ji...ggle the gear stick side to side a little"
it will slide in .5mm more when it set in and the linkage will now be locked. or ther will be a spring button on the front that you push in.

then get under the car lie near the rear gearbox mount and look up you will see a clamp next to a rubber gaitor and a 13mm bolt.
undo this..then inside the car unclip the gear gaitor and on the left hand side of the stick there is a hole line this up with the hole just below it and show another drill bit in that fits.

get back under the car and tighten the bolt you undid.
remove the dril bit from the gear stick, then the one from the gearbox.
put the plastic ...plug back in and clip the gear gaitor back on
lower the car

and all your gears should go straight in.

Re: clutch

Posted: Mon Apr 26, 2010 9:12 pm
by redtop c
wew tithead watch it lol things sdoin my head in

and cheers for the reply mate but had gears before the clutch went and jsut done a simple change,
ive jsut been up when i dip the clutch i will start now but wen bring the clutch back up its still in gear cheers