Rear End ;)

Help and advice section for technical questions on your Corsa.
Please check that your query hasn't already been answered in FAQ and Technical Info section.

Moderator: Octane2097

User avatar
donnay1991
CB-Uk User
Posts: 519
Joined: Thu May 27, 2010 1:24 pm
Location: Angus, Scotland

Rear End ;)

Post by donnay1991 »

Now most of you are probably used to looking at rear ends;) anyway joke over. I want to debadge mine, using just a card and some tar remover? if that will work good? butttt, coz its red and they fade coz there poo. if i removed badge and used tar remover would u see where the writing had been? just because that bit aint faded. really need a bit of t-cut and elbow grease ( ca be arsed ).

Pic - Image
Cheers
Corsa B 1999 1.2 16v,
Debadged, Lowered 40 mm front and back 60mm,angel eyes with standard rears, Smoked Side Repeaters, Drilled airbox (Shredded). 4" Sportex Backbox with sportex straight through centre pipe. Graphite grey cesaros.
User avatar
mike_stout_
CB-Uk Newbie
Posts: 44
Joined: Sun May 23, 2010 2:12 pm

Re: Rear End ;)

Post by mike_stout_ »

if it looks terriable you can allways put them back on i did.
User avatar
donnay1991
CB-Uk User
Posts: 519
Joined: Thu May 27, 2010 1:24 pm
Location: Angus, Scotland

Re: Rear End ;)

Post by donnay1991 »

what can ya put them on with, just halfords gluey stuff lol
Corsa B 1999 1.2 16v,
Debadged, Lowered 40 mm front and back 60mm,angel eyes with standard rears, Smoked Side Repeaters, Drilled airbox (Shredded). 4" Sportex Backbox with sportex straight through centre pipe. Graphite grey cesaros.
User avatar
donnay1991
CB-Uk User
Posts: 519
Joined: Thu May 27, 2010 1:24 pm
Location: Angus, Scotland

Re: Rear End ;)

Post by donnay1991 »

just to add** what if i use a card right, and some paint comes off or something? and emmm, does tar remover just remove the glue completely?
Corsa B 1999 1.2 16v,
Debadged, Lowered 40 mm front and back 60mm,angel eyes with standard rears, Smoked Side Repeaters, Drilled airbox (Shredded). 4" Sportex Backbox with sportex straight through centre pipe. Graphite grey cesaros.
User avatar
Timmeh
CB-Uk User
Posts: 80
Joined: Thu Apr 15, 2010 6:02 pm
Location: Northfield, Birmingham

Re: Rear End ;)

Post by Timmeh »

i used a hair dryer and some dental floss on my flame red corsa. use a dry rag to rub the glue residue off. It takes the piss to do, but worth taking time over. a rush job will end up peeling paint off or damaging the finnish. You could see where the writing was, but just t cut it over and over and over again. i t cutted the small area where the badges were, about 30 - 40 times. whole process took about 2 hours but look sooooo much better.
Pre-facelift Bumpers FTW!
User avatar
donnay1991
CB-Uk User
Posts: 519
Joined: Thu May 27, 2010 1:24 pm
Location: Angus, Scotland

Re: Rear End ;)

Post by donnay1991 »

Cheers Timmeh! in the middle of doing it now lol. dental floss the writing off haha. rubbing the glue off is a badger! :( ahwell. it will look good. i hope! Fingers Crossed
Corsa B 1999 1.2 16v,
Debadged, Lowered 40 mm front and back 60mm,angel eyes with standard rears, Smoked Side Repeaters, Drilled airbox (Shredded). 4" Sportex Backbox with sportex straight through centre pipe. Graphite grey cesaros.
User avatar
lee_uk
CB-Uk Newbie
Posts: 33
Joined: Tue May 04, 2010 8:21 pm
Location: Tyne & Wear

Re: Rear End ;)

Post by lee_uk »

I got mine off with nothing more than a kettle full of almost boiling water to losen the glue and dental floss (see saw action going diagional). Then removed the remainder of the glue a cloth with soapy water (and occasionally added a little more water from the kettle) Took about an hour to get the rear done like that.
Lee_UK - 1998 "S" Reg Corsa Merit 1.0 12v
User avatar
Samo92
CB-Uk Newbie
Posts: 21
Joined: Mon Mar 29, 2010 9:45 pm

Re: Rear End ;)

Post by Samo92 »

i used a kettle, my student card (finally found a use for it lol), and a scrubbing brush, no scratches or anything, mines the argon blue corsa and you cant see where theyve been unless you hold the boot up so it hits the light and your actually looking for it, what i did though was removed the smallest badge first, in my cas the 1.0 one and if it went well i went for the rest, if its a bit faded try a bit of polish or wax too

anyway hereas a pic of mine

Image
i would love to know how to add my signiture :@
User avatar
donnay1991
CB-Uk User
Posts: 519
Joined: Thu May 27, 2010 1:24 pm
Location: Angus, Scotland

Re: Rear End ;)

Post by donnay1991 »

dont look too bad mate. mine took like 10 mins for 1 letter :( u sed soapy water and a towel lol. i tried towel with petrol haha and water or just dry aswell. What can i use to get th glue off? or will it just take time :(
Corsa B 1999 1.2 16v,
Debadged, Lowered 40 mm front and back 60mm,angel eyes with standard rears, Smoked Side Repeaters, Drilled airbox (Shredded). 4" Sportex Backbox with sportex straight through centre pipe. Graphite grey cesaros.
User avatar
duncanpound
CB-Uk User
Posts: 449
Joined: Wed Dec 30, 2009 5:10 pm
Location: Shropshire/Herefordshire/Worcestershire Borders

Re: Rear End ;)

Post by duncanpound »

white spirit gets the glue off
[size=150][b][color=#008000]Corsa B W Reg[/color][/b][/size]

[color=#008000][u][b]check out my project log[/b][/u][/color] http://forums.corsa-b.co.uk/viewtopic.php?f=81&t=14330
User avatar
PRICER
CB-Uk User
Posts: 3510
Joined: Sun May 10, 2009 9:21 pm
Location: ludlow shropshire

Re: Rear End ;)

Post by PRICER »

orr a toffee wheel gets it off, orr what i used last time was T-cut
TURBO LAG IS JUST FOREPLAY ;)

2.0 16v GSI SPORT TWIN WEBER 45'S AND KENT CAMS :]
User avatar
donnay1991
CB-Uk User
Posts: 519
Joined: Thu May 27, 2010 1:24 pm
Location: Angus, Scotland

Re: Rear End ;)

Post by donnay1991 »

white spirit takes the paint off
Corsa B 1999 1.2 16v,
Debadged, Lowered 40 mm front and back 60mm,angel eyes with standard rears, Smoked Side Repeaters, Drilled airbox (Shredded). 4" Sportex Backbox with sportex straight through centre pipe. Graphite grey cesaros.
User avatar
duncanpound
CB-Uk User
Posts: 449
Joined: Wed Dec 30, 2009 5:10 pm
Location: Shropshire/Herefordshire/Worcestershire Borders

Re: Rear End ;)

Post by duncanpound »

not on mine it didnt

how did u apply it, pour onto the paintwork or dab onto cloth and rub like f**k
[size=150][b][color=#008000]Corsa B W Reg[/color][/b][/size]

[color=#008000][u][b]check out my project log[/b][/u][/color] http://forums.corsa-b.co.uk/viewtopic.php?f=81&t=14330
User avatar
donnay1991
CB-Uk User
Posts: 519
Joined: Thu May 27, 2010 1:24 pm
Location: Angus, Scotland

Re: Rear End ;)

Post by donnay1991 »

nevr used it, bt white spirit is used fr removn paint
Corsa B 1999 1.2 16v,
Debadged, Lowered 40 mm front and back 60mm,angel eyes with standard rears, Smoked Side Repeaters, Drilled airbox (Shredded). 4" Sportex Backbox with sportex straight through centre pipe. Graphite grey cesaros.
User avatar
PRICER
CB-Uk User
Posts: 3510
Joined: Sun May 10, 2009 9:21 pm
Location: ludlow shropshire

Re: Rear End ;)

Post by PRICER »

yea but it doesnt affect car paintwork, well everyone i know uses it, it takes a while but it works.l
TURBO LAG IS JUST FOREPLAY ;)

2.0 16v GSI SPORT TWIN WEBER 45'S AND KENT CAMS :]
Post Reply