Page 1 of 1
Cav SRi 2.0 8v transplant
Posted: Sat May 28, 2005 10:09 pm
by simon_p
I own a 1.0 12v, but have been offered the above mentioned engine very cheap.
He has the engine, intake system, ECU, loom but no gearbox.
Except the gearbox, what else will i need? is it an easy job? has any one on here done it?
Also, would the cav SRi front discs and calipers fit on the corsa? what about the rear?
All help gratefully recieved!!!
Cav SRi 2.0 8v transplant
Posted: Sun May 29, 2005 8:52 pm
by j1400
Dirve shafts from cav, astra MK2/3 calibra.
converison hubs
2L mount+body mount
then all other bits like air fitler and so on, and someone to fit it, lol
Cav SRi 2.0 8v transplant
Posted: Mon May 30, 2005 5:03 pm
by Breeze
Hey Simon, whereabouts in Selby are you from? Do you go to Selby College?
Cav SRi 2.0 8v transplant
Posted: Tue May 31, 2005 8:50 pm
by simon_p
[quote=\"Breeze\"]Hey Simon, whereabouts in Selby are you from? Do you go to Selby College?[/quote]
no, im down primrose grove wots ur name? i went to york, but have now got a job at eggborough power station
back on topic
[quote=\"J1400\"]Dirve shafts from cav, astra MK2/3 calibra.
converison hubs
2L mount+body mount[/quote]
how much are we looking at cheapest here? how much would the gearbox be from a scrappers do you reckon? is it the f20 box i need?
do i need different hubs for the brakes? i looked at the calipers and the only difference is they need bigger disks. Didn\'t try the disk as it was at his dads house
Cav SRi 2.0 8v transplant
Posted: Thu Jun 02, 2005 8:15 pm
by simon_p
can any one shed any light on the brakes?
Cav SRi 2.0 8v transplant
Posted: Fri Jun 03, 2005 1:21 pm
by Dodgy Dave
there was another thread about this a while ago, it may be on another page but its got the info in there
Cav SRi 2.0 8v transplant
Posted: Fri Jun 03, 2005 9:56 pm
by simon_p
[quote=\"Dodgy Dave\"]there was another thread about this a while ago, it may be on another page but its got the info in there[/quote]
cant find it mate
please help tho!
Cav SRi 2.0 8v transplant
Posted: Sat Jun 04, 2005 1:48 pm
by Dodgy Dave
ok then for the conversion you will need
engine mounts ( 2 mounts needed cuz u got a 12v, if u had an 8v u would of only needed the one)
hubs
drive shafts
ecu and loom off donor car
gear linkage lengthened
up-rated suspension
up rated breaks (all the needs doing is the discs and pads, no need for further up grades unless u go over 160bhp)
gear box spacer mount
8mm fuel lines
muliti point injection fuel pump
and loads of tools
wd40 and lots of time
i cant think of any more at the moment
but u can get a conversion kit from Regal auto sport,
www.regal-shop.co.uk, the kit is about £400 and consists of, engine mounts, gear box spacer, drive shafts and hubs, plus instructions to do the conversion