Corsa-B.uk - Vauxhall, Opel and Holden Corsa B Owners Club

hi i bought some alloy wheels 15 inch tsw but they where of a peugeot 206 and i have just found out the holes dont line up with the holes on the hub is there anything i can get so they will fit thanks.

get big hammer and chisel lol.

not really anything you can do im affraid mate, just sell them and make sure you get the right ones next time. dont worry loads of people make the same mistake

cheers for that mate and corsaedi no that would just make things worse lol.

peugeot 206's are 4x108 so even with wobble bolts they woldnt fit unfortunatly so you will have to sell them on like matty says and get s some vauxhall wheels, will look better anyways

If you take them to a local engineer they will be able to drill a second set of bolt holes so they fit on your car

that would depend how different the holes are apart, if they were closerthan about 10mm they probly wudnt.

think of multi fit wheels, they manage to get 4x100 and 4x108 pattern on one wheel no probs.

yh it cud be possible, but you could do all that and then the offset will be wrong, think its et25 for a 206.

i personaly dont like multifit wheels there never looks like enough meat between the holes to handle any abuse

essexjhon do you rekon that would work because there on ebay now for 150 thats what i payed for them there been on ebay for two days and no bids yet but they got about 8 days left so after that if they dont sell i am going to put them in the yellow paper see how that goes but can it cause any other problems drilling extra holes apart from the et cheers.

www.alloytrader.net

check it out and its free

i will try that if they dont sell on ebay cheers matty.

marshy52 wrote:essexjhon do you rekon that would work because there on ebay now for 150 thats what i payed for them there been on ebay for two days and no bids yet but they got about 8 days left so after that if they dont sell i am going to put them in the yellow paper see how that goes but can it cause any other problems drilling extra holes apart from the et cheers.

The wheels on my old astra gsi had this done to them and they were fine, but depends on the offset, normally 206 are et25 so you'd need spacers to bring the wheel further out in the arch. May work out cheaper the sell them and get new wheels!