Clunking on the front
Posted: Thu Feb 03, 2011 8:37 pm
Hi All,
Recently I have been hearing a clunking noise on the front, especially when parking up or setting off slowly, seems to be coming from the wheels and is a rather loud clunk noise, almost sounds/feels like something is slipping?
You can also hear it when parked up, if you turn the wheel left to right, Also I have had someone inside the car doing it while i've been outside and you can seem to hear it more in the middle of car? Have been down near both front wheels where you can hear it, but sounds even from the middle.
Is there anything that I can get under the car and check ?
Another problem I seem to be having are rear wheel bearings !
I have had them replaced a few times and every few month they seem to be dieing out eg rumbling noise.
Is it just a case of replacing the bearings and thats it, or does the centre nut need tightening up a little more once the bearings worn in ? Which iv heard. If this is the case do you think it is ok to tighten the nut up a little now as I am starting to hear a little rumble, or would it be best to replace the bearings and then re-tighten after say 100miles?
Thanks for any help !
Recently I have been hearing a clunking noise on the front, especially when parking up or setting off slowly, seems to be coming from the wheels and is a rather loud clunk noise, almost sounds/feels like something is slipping?
You can also hear it when parked up, if you turn the wheel left to right, Also I have had someone inside the car doing it while i've been outside and you can seem to hear it more in the middle of car? Have been down near both front wheels where you can hear it, but sounds even from the middle.
Is there anything that I can get under the car and check ?
Another problem I seem to be having are rear wheel bearings !
I have had them replaced a few times and every few month they seem to be dieing out eg rumbling noise.
Is it just a case of replacing the bearings and thats it, or does the centre nut need tightening up a little more once the bearings worn in ? Which iv heard. If this is the case do you think it is ok to tighten the nut up a little now as I am starting to hear a little rumble, or would it be best to replace the bearings and then re-tighten after say 100miles?
Thanks for any help !