MID bulbs
Posted: Thu Aug 08, 2013 12:59 pm
I thought they were 509t's but after buying some it would seem I was wrong. The T's seem very close. Which ones do I need?
Corsa-B.uk - Vauxhall, Opel and Holden Corsa B Owners Club
MID bulbs
Page 1 of 2
Re: MID bulbs
Posted: Thu Aug 08, 2013 1:25 pm
509t is the correct bulb
Re: MID bulbs
Posted: Thu Aug 08, 2013 5:54 pm
I've got an extra plastic piece either side that's stopping my pushing the bulb in. Hang on, will post a pic
Re: MID bulbs
Posted: Thu Aug 08, 2013 6:02 pm
Are you on about the clock ? Yeah getba pic up
Re: MID bulbs
Posted: Thu Aug 08, 2013 6:19 pm
They have an extra pair of plastic bits either side by the bulb which a stopping them fitting into the MID.
Re: MID bulbs
Posted: Thu Aug 08, 2013 6:21 pm
johnny wrote:Are you on about the clock ? Yeah getba pic up
Sorry no, the multi info display
Re: MID bulbs
Posted: Thu Aug 08, 2013 6:31 pm
The corsa doesnt have a multi info display, did you fit it from somthing elseBighed wrote:johnny wrote:Are you on about the clock ? Yeah getba pic up
Sorry no, the multi info display
Re: MID bulbs
Posted: Thu Aug 08, 2013 6:36 pm
Sorry. So what's the part on the dash top called with time, temp etc on it?
Re: MID bulbs
Posted: Thu Aug 08, 2013 6:41 pm
Aw yeah thats the bit i ment with the clock sorryBighed wrote:Sorry. So what's the part on the dash top called with time, temp etc on it?
Them bulbs should fit just push in its only the metal bit that goes in
Re: MID bulbs
Posted: Thu Aug 08, 2013 7:28 pm
The two plastic "wings" are stopping them
Re: MID bulbs
Posted: Thu Aug 08, 2013 8:15 pm
509t is 100% the right bulb so i dont know why it wont go inBighed wrote:The two plastic "wings" are stopping them
Re: MID bulbs
Posted: Fri Aug 09, 2013 2:22 am
There should be a gap to cater for the wings, place it in then twist they should stay there pal
Re: MID bulbs
Posted: Fri Aug 09, 2013 9:24 am
The gap is for the metal contacts to go through to contact on the PCB at the back. These wings are plastic and on the total opposite side to the metal ones
Re: MID bulbs
Posted: Fri Aug 09, 2013 1:06 pm
Try a T5 bulb it should work,Bighed wrote:The gap is for the metal contacts to go through to contact on the PCB at the back. These wings are plastic and on the total opposite side to the metal ones
Http://pages.ebay.com/link/?nav=item.vi ... 0667320876
Re: MID bulbs
Posted: Fri Aug 09, 2013 1:44 pm
Or you could get some side cutters, cut the plastic wings off? = profit