Page 1 of 1

Cam chain rattle

Posted: Thu Aug 15, 2013 9:50 am
by Bighed
1.2 16v. Is it true that changing to 5w 30 oil quietens it down?

Re: Cam chain rattle

Posted: Thu Aug 15, 2013 10:29 am
by johnny
A tiny bit but the only real way is more oil changes

Re: Cam chain rattle

Posted: Thu Aug 15, 2013 3:54 pm
by PowerPie5000
You might find out if you have any leaky seals/gaskets too if you switch over to 5w30 (as it's thinner). My Corsa SXi has had regular oil changes, but it still rattles and i think it's down to the crap tensioners they used. I've been quoted £135+VAT to replace the complete kit (chain, tensioners, guide rails, gears etc...)... This is the price if i supply the parts.

Re: Cam chain rattle

Posted: Thu Aug 15, 2013 4:22 pm
by scorpiotn1
Speaking of Oil on this subject i still think im leaking a bit only when driving. seem to leak in between the oil sump and bell housing. even with all the seals replaced etc. strange one.

Re: Cam chain rattle

Posted: Thu Aug 15, 2013 4:39 pm
by PowerPie5000
scorpiotn1 wrote:Speaking of Oil on this subject i still think im leaking a bit only when driving. seem to leak in between the oil sump and bell housing. even with all the seals replaced etc. strange one.
Have the front/rear cranks seals been replaced too? I had my sump gasket and oil pressure switch replaced a little while ago which sorted 90% of my oil leaks... There's still a very tiny leak coming from somewhere and it ends up dripping off the bottom of the bell housing. I've been told it could be one of the crank seals, but it's not really an issue at the moment as the leak is very minimal.

Re: Cam chain rattle

Posted: Thu Aug 15, 2013 6:25 pm
by scorpiotn1
Thats the same as my car then ! i restored my engine from top to toe and yes the crank seals were replaced too so i cant figure it out. i was thinking of putting a skim of liquid gasket on the bell housing but i was afraid of the oil gathering up and going into the gearbox / flywheel. or pooling up and leaking higher up the engine.