Hi, i tried to spray my corsa b bumpers silver but the paint just went all bubbley and it runs a lot too, it leaves black spots and an awful finish, so i resprayed black and that was fine?
I'm not using primer, is this the case? because when i spray it black its fine!
Spraying Corsa B black bumpers
Moderator: Octane2097
-
- CB-Uk Newbie
- Posts: 44
- Joined: Mon Sep 23, 2013 2:05 pm
- rsi-dan
- CB-Uk User
- Posts: 1323
- Joined: Mon Dec 20, 2010 1:06 am
- Location: Crewe
Re: Spraying Corsa B black bumpers
First things first is prep better prep the better end result
Sand down with a fine grade wet n dry paper then clean up with a rag and white spirit then the same with very fine wet n dry and clean the surface should be smooth
Once dry use so plastic primer not normal primer as that will just flake off and give 3+ coats
Then paint the colour of you car again 2-3 coats is best
The 3-4 coats of laquer for a deep shine
Hope this helps
Sent from my GT-I9100 using Tapatalk 2
Sand down with a fine grade wet n dry paper then clean up with a rag and white spirit then the same with very fine wet n dry and clean the surface should be smooth
Once dry use so plastic primer not normal primer as that will just flake off and give 3+ coats
Then paint the colour of you car again 2-3 coats is best
The 3-4 coats of laquer for a deep shine
Hope this helps
Sent from my GT-I9100 using Tapatalk 2
- johnny
- Senior Moderator
- Posts: 4875
- Joined: Sun Jul 08, 2012 4:26 am
- Location: Donegal,Ireland
Re: Spraying Corsa B black bumpers
As said your finish depends on how good your prep is
To spray them standard plastic bumpers theres alot of sanding, theres a bumpy sort of grain through them and it has to be sanded out completly to leave it smooth
Spraying any part of the car is a fair bit of work,
To spray them standard plastic bumpers theres alot of sanding, theres a bumpy sort of grain through them and it has to be sanded out completly to leave it smooth
Spraying any part of the car is a fair bit of work,
If it doesn't fit,
force it,
If it breaks,
It needed replacing anyway
force it,
If it breaks,
It needed replacing anyway