Corsa-B.uk - Vauxhall, Opel and Holden Corsa B Owners Club

I've plugged the connector into that earth point on the back of the engine block (which can be seen in the photo below), but this one electrical connector continues off that loom and gets to about here.

Photo is taken from underneath the car. Plug is resting on top of the starter:



Hoping someone can help?

What engine was in, whats in now? What loom is it

Hi there, and apologies for the newb error. I'll update my sig.

It's a Corsa b - X12XE 1.2 16v AUTO

I've just put a replacement engine in, which is the same spec as original.

I've put the origincal ECU onto this engine.

Everything has been connected back up EXCEPT this one plug.

There should be somthing close to it that it plugs into then tbh have you checked everywhere.close to it

I've looked and looked, and I just can't figure it out, or see an empty socket that i might connect to anywhere!

As i say, the same loom has a plug on it which goes to the Earth point on the back of the block.

Hoping that someone might know...or could have a look on their motor for me please?

Il take a look tomorrow if i get a chance as cant think of any connecters there

thank you mate, i'd really appreciate that

I couldnt see that connection.on my car mate, pm taurus on thecorsa if he doesnt know, no one will

Ok Will do. Here's some better pictures of it that might help to identify. It has 90 degree corner moulding to it.

Tracing just a little way back on that same loom is the plug to an earth point on the back of the block.

It looks really fimilar but i cant think where its fpr il take a better look after work

All sorted. Twas the crank sensor plug underneath the starter. I had the driveshaft boot obsuring my view of it from underneath! Doh!

That explians why it looked fimilar dont know how i missed it on my car now