Page 1 of 1

No display on MFD when radio turned on.

Posted: Tue Feb 18, 2014 8:10 pm
by AndyLFC67
Hi,
Ive got a 98 Corsa into which ive just installed CDR500 radio/CD to replace the original unit.

All works fine except when I turn it on the middle section of the MFD goes blank so I dont know which radio station im listening to. It did the same with the previous Grundig radio but that had its own LCD display so it wasnt a problem.

Othewise the MFD works fine so im guessing its a wiring issue, Cheers,

Andy

Re: No display on MFD when radio turned on.

Posted: Tue Feb 18, 2014 8:14 pm
by andy w
Hi there on the back of the stereo Andy does it have both all jack plugs because if not that's y it dint work most have this problem and it ain't because of your wiring mate

Re: No display on MFD when radio turned on.

Posted: Tue Feb 18, 2014 10:46 pm
by AndyLFC67
Thanks for the reply. Not sure what you mean about jack plugs - its just got the slide in cage and block connector at the back.

I didnt have to mess with wiring at all, its all bog-standard. Cheers

Andy

Re: No display on MFD when radio turned on.

Posted: Tue Feb 18, 2014 11:14 pm
by johnny
I think it needs to be programmed to it again via opcom or tech2, not sure if generic stuff can do it, call down to your local garage and ask

Re: No display on MFD when radio turned on.

Posted: Sat Feb 22, 2014 11:26 am
by AndyLFC67
Thanks for the replies.
So are there any head units (pref CD) that will work with the Corsa B MFD?
Cheers,

Andy

Re: No display on MFD when radio turned on.

Posted: Sat Feb 22, 2014 11:48 am
by Domwhitex
My sony xplod works with it fine buddy


Sent from my iPhone using Tapatalk

Re: No display on MFD when radio turned on.

Posted: Thu Feb 27, 2014 9:54 am
by AndyLFC67
Thanks for the replies folks but ive sorted it.

Pressing 3 & 5 on the radio switches the display output & now working fine. Cheers,

Andy

Re: No display on MFD when radio turned on.

Posted: Thu Feb 27, 2014 9:55 am
by AndyLFC67
Thanks for the replies folks but ive sorted it.

Pressing 3 & 5 on the radio switches the display output & now working fine. Cheers,

Andy