Page 1 of 1
Need some ideas.
Posted: Sun Mar 30, 2014 9:00 pm
by stanc3w0rks
Came across this, its out of an audi a4 iirc. And ideas how i could get it to fit somewhere in my corsa?
Sent from my Ascend G300 using Tapatalk
Re: Need some ideas.
Posted: Sun Mar 30, 2014 9:01 pm
by Blackie_No1
Does your car have a passenger side airbag? If not you could fit it to the plastic panel above the glovebox
Re: Need some ideas.
Posted: Sun Mar 30, 2014 9:04 pm
by stanc3w0rks
I have no airbags or glovebox lol
Sent from my Ascend G300 using Tapatalk
Re: Need some ideas.
Posted: Sun Mar 30, 2014 9:10 pm
by stanc3w0rks
What about this? Would be a bit handy because i dont want to cut any panels or anything
Sent from my Ascend G300 using Tapatalk
Re: Need some ideas.
Posted: Sun Mar 30, 2014 9:11 pm
by johnny
I was thinking about fitting One of these but I never got round to it, I was just going to go in just above the glove box, just remember to measure and mock it up plenty of times before you cut your dash
Re: Need some ideas.
Posted: Sun Mar 30, 2014 9:13 pm
by stanc3w0rks
I dont fancy cutting my dash but that would be the perfect place imo, i just dont ave the skills to do it, its the round panel your on about isn't it?
Sent from my Ascend G300 using Tapatalk
Re: Need some ideas.
Posted: Sun Mar 30, 2014 9:34 pm
by Blackie_No1
Yup
Re: Need some ideas.
Posted: Sun Mar 30, 2014 9:37 pm
by stanc3w0rks
That would be the best place for it but i would probably butcher it tbh
Sent from my Ascend G300 using Tapatalk