Page 1 of 1
Wiring...
Posted: Tue Oct 27, 2015 7:46 pm
by scamp123
Hey guys, I had stripped out all the plastic trim along the sills of my 3 door Corsa while cleaning it. I found a loom that ends just after the b-pillar, by the base of the rear seats. Does anyone have an idea what it is?
Re: Wiring...
Posted: Tue Oct 27, 2015 10:49 pm
by johnny
Is it a small loom with a single plug?
Re: Wiring...
Posted: Tue Oct 27, 2015 10:57 pm
by stanc3w0rks
Could it be for heated seats?
Sent from my GT-I8200N using Tapatalk
Re: Wiring...
Posted: Wed Oct 28, 2015 10:28 pm
by scamp123
yeah its a wee three pin single plug.
Re: Wiring...
Posted: Thu Oct 29, 2015 12:08 am
by johnny
More than likely heated seats loom
Re: Wiring...
Posted: Thu Oct 29, 2015 2:20 pm
by scamp123
i dont have the front seat loom though...
Re: Wiring...
Posted: Thu Oct 29, 2015 6:27 pm
by johnny
What do you mean? That plug would be for the front seats
Re: Wiring...
Posted: Thu Oct 29, 2015 11:27 pm
by scamp123
i dont have the plugs behind the air recirc trim for the heated seat switches......
Re: Wiring...
Posted: Thu Oct 29, 2015 11:32 pm
by stanc3w0rks
I thought all looms were the same for all models?
Sent from my GT-I8200N using Tapatalk
Re: Wiring...
Posted: Fri Oct 30, 2015 1:26 am
by johnny
Yeah all looms are the same so the loom for heated seats will be there but not necessarily the plugs in the dash, the wires and maybe plugs will be taped up somewhere
Re: Wiring...
Posted: Sat Oct 31, 2015 12:18 am
by scamp123
sweet, didnt know that, gonna have a dig when i take his dash out to put in the new backlighting
Re: Wiring...
Posted: Sat Nov 07, 2015 8:02 am
by diggerhole
Two threads... and an almost identical answer...[emoji13]
The wiring for the rear will end in the passenger footwell behind the kick panel. This would be the best place to look for it to start. The Corsa and Combo are effectively 5 looms. Engine, dashboard, rear and 2 door looms . The main 3 all meet up in a big block connector in the footwell. So you may well have the block by the b piller but for cost saving no front wiring. Time to break out the multimeter.
Sent from my SM-G928F using Tapatalk