Corsa-B.uk - Vauxhall, Opel and Holden Corsa B Owners Club

have seen some shiny ones to replace the black ones, do they just screw on? or will i need to do any modding?

LOL, yes they screw on

yes 3cm they screw on.............

they will get pinched thou

They screw on and they screw off. Just hang around outside your local amusement arcades and steal them off the BMX\'s.

i did mine up with locktite and pliers, and now i cant get them off to fill my tyres up with air

No biggie - just tap a small hole in with a nail and quickly pull it out and shove an air line in.
When it\'s pumped up, just pop rivet the hole up.

gt85

GT85 won\'t undo loctite\'d threads. Did you use thread lock locktite (the red stuff) or actual superglue....

[quote=\"Adam-D\"]yes 3cm they screw on.............

they will get pinched thou[/quote]

fcukabout

unless you get some of the new richbrook spinning anti theft ones that is.

[quote=\"rick\"]unless you get some of the new richbrook spinning anti theft ones that is.
[/quote]

On a similar style, the spinner section fails and you\'re then not able to get a grip on the cap at all! Not sure if Richbrook\'s ones are the same.

Stick with black plastic valve caps.

i think they should make them with a torx safety screw at the top, no one carries that tool around with them

done it

took 3days from start to finish, i didn\'t know where to keep the air i removed from the tyre so had to rig up a device to catch the air so i could re-use it

it was offical yokohoma air i think, came with tyres