Page 1 of 1
spoiler
Posted: Tue Oct 18, 2005 3:11 pm
by morgan100
Im looking to get a spoiler for my corsa b but i dont want a GSI one. Want something like thew MS design one. Just for the top, like a mk4 fiesta spoiler. Any ideas where to get as the MS design one is well expensive IMO. Any ideas where to get one similar cheaper?
Anyone know how much work it would take to make the mk4 fiesta one fit??
spoiler
Posted: Tue Oct 18, 2005 3:28 pm
by Joff
I\'ve got a damaged MS Design one for sale. It\'s snapped cleanly in half so looks bad but would be fairly straightforward for a bodyshop to support inside and smooth over.
The rest of the spoiler is intact.
spoiler
Posted: Tue Oct 18, 2005 3:34 pm
by gareth_towler
cud get AN irmishur one also but xpensive unless u look around alot
spoiler
Posted: Tue Oct 18, 2005 6:15 pm
by morgan100
na, already had problems wit a broken spoiler, thnks nyway. Anyone else got any ideas??
spoiler
Posted: Sat Oct 22, 2005 5:03 pm
by CR41G
spoiler
Posted: Sat Oct 22, 2005 6:11 pm
by tom87
[quote=\"gareth_towler\"]cud get AN irmsher one also but xpensive unless u look around alot[/quote]
na there just the same as the gsi one but with an irmscher badge
, theres not really many spoiler on the market that look good for the corsa apart from the stock vauxhall one. steinmetz might make one but no doubt it will be stupidly overpriced. i know you say you dont want a gsi one but its probably your best bet tbh, cheap, good looking and good quality.
spoiler
Posted: Sat Oct 22, 2005 9:24 pm
by martint2k4
if you get the broken one, you might be able to drill 2 long holes down either side of it, and put 2 steel thin rods inside, then bond it together with resin or similar, then smooth it over with filler? may work
spoiler
Posted: Sun Oct 23, 2005 3:49 pm
by Joff
[quote=\"martint2k4\"]if you get the broken one, you might be able to drill 2 long holes down either side of it, and put 2 steel thin rods inside, then bond it together with resin or similar, then smooth it over with filler? may work[/quote]
Yup, that\'s all it needs. Because it\'s an MS Designs spoiler, it\'s made from PU RIM which is stronger than fibreglass, so can be repaired easier.