Corsa-B.uk - Vauxhall, Opel and Holden Corsa B Owners Club

right

took the car to Jamsport for a checkover and RR run

results are here:



just for the few that suffer from not being able to read, figures are

130bhp @6733rpm and
123lb/ft @4533rpm

thanks to the lads at Jamsport for fitting me in at short notice, and broster for scanning the pic and coming with me

opinions please

nice one.
not a bad figure

Quite healthy that

yep, i\'m happy with it

better than the 105bhp the first run gave

did 4 runs, 105bhp lol, 127bhp, 128 and 130

What engine mods have you done?

lexmaul inlet
janspeed 4-2-1
viper
bfo system with decat
ecu mapped for my old engine which was pretty identicle (by chipwizards)

oh its a 1.6 16v

Shouldn\'t the power output be a tad higher then?

seems like quite a good reading to me, nice one dude

id be pleased with that

[quote=\"corsacant\"]Shouldn\'t the power output be a tad higher then?[/quote]

no, people often think because an engine has mods it should have 5bhp for viper 10bhp for chip 10bhp for lexmaul etc etc! it wont work like that 130bhp is very very good power for the mods done!

i have a 1.6 16v aswell mate it has been chipped but it was done b 4 i got the car it will rev round to 7500rpm does yours do the same??

[quote=\"wayne the wheel\"]i have a 1.6 16v aswell mate it has been chipped but it was done b 4 i got the car it will rev round to 7500rpm does yours do the same??[/quote]

what chip was fitted, robins revs to 7500 because it was mapped not chipped.

oh right not sure as it was done when i got it could do with finding out realy the guy said it was chipped and remapped

Just noticed one thing, the shape looks good, but the torwue bhp crossover is in the worng place should sit at 5250rpm (due to the calculation of BHP from torque, so assumign that peak power and torqur are high :s

no james, the peak torque and power are the same amount at 5252rpm

the crossover point depends on the scales used