Page 1 of 1

Hard changing down gears & crunches going into reverse

Posted: Thu Nov 01, 2007 10:47 pm
by olliejones8
Hi guys
recently i have found it hard changin down gears when driving, ALSO it seriously crunches when tryin to reverse, i mean the kind of noises that make you wana cry and all u can see is £££££ :lol:

PLEASE HELP ME

Cheers

Ollie

Re: Hard changing down gears & crunches going into reverse

Posted: Thu Nov 01, 2007 10:51 pm
by richardhhha
check how slack the clutch cable is, should only have about half and inch on the pedal before you feel it tighten,

then check clutch cable for the white plastic clip ontop of the gear box, if its broken and come off it will cause dificulty changing gear.

also might want to adjust your gear linkage when this is all done.

Re: Hard changing down gears & crunches going into reverse

Posted: Fri Nov 02, 2007 9:22 am
by nitrous6293
yea mine does this too.
it also doesnt like going into 2nd and crunches then

Re: Hard changing down gears & crunches going into reverse

Posted: Sun Jan 13, 2008 8:22 pm
by JonnyDBiker
yeah mine used to do it but garrage tightened up clutch.

Re: Hard changing down gears & crunches going into reverse

Posted: Mon Jan 14, 2008 12:50 am
by Octane2097
i agree sounds like clutch,
get it tightend shouldnt cost much

Re: Hard changing down gears & crunches going into reverse

Posted: Sat Feb 09, 2008 12:07 am
by Gary_billingham
i got same problem started today,gonna get ma haynes out and do it on sunday,hopefully i can do it any way,got tighten up handbrake to lol

Re: Hard changing down gears & crunches going into reverse

Posted: Sat Feb 23, 2008 10:15 pm
by Gary_billingham
i think i know what it is,is your clutch pedal just above your brake pedal,if not it should be,if it isnt,open bonnet,just below and left of battery is the clutch cable,if not sure where that is get someone to keep pressing the clutch till you see it moving,once found there should be some kind of locking pin or something on the inside of the thread,if there isnt this is probably your problem,i didnt have this lock and the thread kept unthreading itself every time i ised clutch and clutch pedal ended up near floor when not even using,just twist with hand the thread and get somebody to tell you when its above the brake pedal,once in place either fit an allready purchased locking pin thing or just use 2 nuts like i did on the end to act like a locking nut,dont see why it should fail MOT,it passed last year and it never had this clip so as far as i see its mor safer this year lol

hope it helps